Advertisement
5 ASSIGNING TO THE SYSTEM
1)
Turn detector counterclockwise.
2)
Start assigning on the Security Hub mobile
or desktop app. Assigning starts for 45-60
sec.
3)
Insert battery into the detector:
Secondary – first
Primary - next
Detector's led start flashing: 5x white flash
4)
in 1 sec.
Make sure that the assigning is successful on
the Security Hub mobile or desktop app. If as-
signing is unsuccessful, repeat the procedure.
6 RESET PROCEDURE
1)
Turn detector counterclockwise.
2)
Close the DEL contacts - the red indicator
will turn on.
3)
After turning off the red indicator, open the
DEL contacts.
The detector generates a notice "No con-
4)
nection" and becomes available for as-
signing to the system.
7 INSTALLATION PLACE
1)
The detector is installed under the ceiling. It
is allowed to install the detector on the wall, as well
as to mount it on a cable. When suspending the
detector on a cable, its stable position and orienta-
tion in space must be ensured.
To eliminate false alarms
2)
It is forbidden to mask the detector, heat
fluxes must freely penetrate through the holes
in the case;
3)
It is forbidden to install the detector in front
of the air conditioner (in the zone of convection
flows).
ATTENTION! Remove the protective cover
immediately before commissioning the detector.
8 INSTALLATION PROCEDURE
2) Mount the base on
1) Remove the elec-
tronic unit from the
ceiling
base
3)
Insert battery.
Secondary – first
Primary - next
4)
Install the electronic unit.
5)
Perform detector test (see section 9).
9 TESTING
The test is performed by the laser tester "Astra-
942" (not included in delivery set).
To activate the «Test» mode:
- press the red button of the laser tester;
- direct laser beam to the detector's LED;
- irradiate the LED for 1 sec.
LED should turn on in red for 2 sec.
detector's LED:
- normal work: 1x red flash in every 2 sec.
during 30 sec.
- if there is a defect or malfunction: 3x red flash
in 25 sec. period.
Security Hub mobile app: fire alarm notifi-
cation.
10 WARRANTY
The operation warranty period is 5 years from
the date of manufacturing, which is indicated on
housing and box of detector.
Mount holes
Advertisement
