Table of Contents
Advertisement
INSTALLATION OF THE FILTERS
1.
To remove the grease filter, push in the metal
latch tab. This will disengage the filter from
the hood. Tilt the filter downwards
and remove.
2.
To install the grease filter, align the rear
filter tabs with slots in the hood. Push in the
metal latch tab, push the filter into position
and release. Make sure the filter is securely
engaged after assembly.
3.
To install the charcoal filter (for recirculating/
optional) and lock it into place as shown in
the diagram bottom right.
4.
Install the grease filter after the charcoal filter
has been installed.
This symbol on the product or in the instruction manual means that your electrical and electronic
equipment should be disposed at the end of its life separately from your household waste. There
are separate collection systems for recycling in the EU. For more information, please contact your
local authority or the retailer where you purchased the appliance.
When you unpack the appliance, make sure that it has not been damaged in any way. If you have
any doubts at all DO NOT INSTALL OR USE THE APPLIANCE. In this instance please contact your
retailer or Daniela Appliances direct. Keep packing material such as plastic bags, polystyrene,
nails or screws out of the reach of children, as they are a choking hazard.
P
I
02 9604 1226
E
I
sales@danielaappliances.com.au
W
|
danielaappliances.com.au
PA G E 1 1
Advertisement
Table of Contents
