Subscribe to Our Youtube Channel
Summary of Contents for Warmup WSM-200W
- Page 1 ™ The world’s best-selling electric floor heating brand WSM-200W Instruction Manual warmup.com | (888) 927-6333...
- Page 2 Product Description The Warmup WSM-200W is a WiFi- Enclosure NEMA 1 for indoor mounting enabled panel to operate your in-ground snow melting system. panel contains load switching capabilities Relays Four (4) 240V/60A Relays to 240A/240V) and is triggered by the...
- Page 3 PANEL LAYOUT Figure 1 WSM200W controller has four (4) - 240VAC/60A contactor relays. contactor relay requires a 240VAC/60A dedicated inbound circuit (see Figure 1, #1 & 2). This contactor relay will supply power to the transformer (see Figure 1, #3) . The transformer will supply power to the Ground Fault Relay, the Manual Timer, and the WiFi Relay (see Figure 1, #4, 5 &...
- Page 4 ON/ OFF button. The timer can be set from 1 to 99 hours and Warmup defaults the timer at 1 period of 10 hours. We do not recommend less than 5 hours for proper snow melting results.
- Page 5 MANUAL TIMER SETTINGS 80.1 FINDER TIMER SETTINGS T1-K KLEMSAN TIMER SETTINGS Set the top orange dial to 1. Set the top gray dial to 24h Set the middle orange dial 2. Set the middle blue dial to the to the number of "run number of "run time"...
- Page 6 Smartphone Application To activate your WSM-200W automatically as it was designed to be, you must first download Warmup application available in your iOS or Android app store. Upon download, verify that your system is properly wired and powered so that it can emit the necessary signals to your home’s WiFi router.
- Page 7 The temporary switch to Shelley network allowed WSM-200W to pair up with your phone specifically and it will now link directly with your home’s router. Over the next few screens you will be guided to set up your system and name it.
- Page 8 Default parameters have been preloaded for a typical snow melting system. You can click on the EDIT icon (pen and paper) of your snow melting system and change the following: EDIT NAME If you wish to change the name of your system you can do it here.
- Page 9 BELOW 0°F It is recommended to not allow the system to function when outdoor temperatures are below 0°F / -18°C. This is because the power required to heat the slab to 40°F is simply too great and it is possible that the system may not cope with the requirement.
- Page 10 Wiring Diagram SUPPORT Online www.warmup.com Technical Helpline (888) 927-6333...
Need help?
Do you have a question about the WSM-200W and is the answer not in the manual?
Questions and answers