Installing a Power Supply in a Cisco 3825 Router
Follow these steps to attach the power supply to the power supply tray.
Step 1
Turn the tray right side up. Align the new power supply with the front wall of the tray.
Step 2
Replace and tighten the screws that hold the power supply to the tray.
Verify that the primary power cable is connected to the motherboard as shown in
Figure 69
1
Primary power cable
If you are finished installing components inside the router, continue with the
Supply Assembly in a Cisco 3825 Router" procedure on page
To install an SDRAM DIMM, continue with the
on page
To install a PVDM, continue with the
Installing and Upgrading Internal Components in Cisco 3800 Series Routers
100
Primary Power Cable Motherboard Connection
85. To install an AIM, continue with the
105.
"SDRAM DIMM Removal and Installation" procedure
"AIM Installation and Removal" procedure on page
"PVDM Installation and Removal" procedure on page
Figure
69.
1
"Reinstalling the Power
96.
OL-5975-04
88.