Nobile 9109011003 Mounting And Operation Instructions page 2

Mounting-/
Operation Instruction
EN
Safe use of the product is only guaranteed if each instruction is followed accordingly. In case of damage caused by non-observance of these
instructions the warranty expires. The installation and electrical connection must be done by an authorized expert (e.g. electrician) in compliance
with existing standards and local code. Prior to any installation or maintenance work, mains must be disconnected. Before putting in operation,
make sure any component of the entire installation does not bear a risk of life. According to common practice, please perform a standard function
test, before installing. To make maintenance work possible, the lighting system should be accessible after installation (auditable).
Technical Specification
Transmission protocol
Operation Frequency
Transmission Power
BLE Range
Battery
Ambient Temperature Ta
Mounting:
Before using the device, first unscrew the backside with the provided screw driver then remove the protective foil on the battery.
Commissioning
To add the device in your nobile Smartmatic 2.0 App, select "Add Device". Press the button for 5 seconds until the LED starts blinking. The device
icon will appear in the nobile Smartmatic 2.0 App screen. Then select "Add", this will take from 10 seconds to 2 minutes depending on the signal
strength. Select "Next", you will see a "Added successfully" notification signifying that the device is now added in the app. Then lastly select "Done"
Controlling the Device:
To be able to control a device, it should be set on "Add intelligence". Under "Task" is the "Device" field where all registered device in the Smartmatic
2.0 App can be found. Choose the desired device to control. Then under "When the condition is Met" set a condition of 1) single click, 2 double
click or 3) long press
Switch push button mini 3-way BT
BLE 4.2
2.40 GHz
10 dBm
up to 90 meters in free field
CR2032
-10 ~ 50°C
Technische und gestalterische Änderungen im Zuge stetiger Produktentwicklungen vorbehalten.
Technical and design changes due to product developments are subject to change without prior notice.
nobilé AG – Wächtersbacher Str. 78 - 60386 Frankfurt/M. Germany - www.nobile.de
For more specifications, please
refer to the data sheet of this
product.
free to download
nobile Smartmatic 2.0 APP
on Google Play or Apple APP Store
Blinking
LED
OFF
Reset or enter
configuration
mode
Button
Trigger to report
current status
rev. 0.0 – 08.04.2022
The device enters BLE
network configuration
mode(preparing to connect the
gateway)
The device is under standby
status
Press and hold the button for 5
seconds until the blue LED
blinks, the device will enter
configuration mode
When the device is under
standby status, press the
button one time and the device
will report its current status to
gateway.