TOP VEHICLE TECH KWSAA1 Installation Manual

Saab 9-3 (8j) 2006-2012

Advertisement

KWSAA1
SAAB 9-3 (8J)
2006-2012
INSTALLATION MANUAL
V1.0321
This dash image is a visual representation for display purposes only.
The information provided in this document is subject to change without notice due to changes and/or
improvements to the product/s.
www.topvehicletech.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the KWSAA1 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for TOP VEHICLE TECH KWSAA1

  • Page 1 KWSAA1 SAAB 9-3 (8J) 2006-2012 INSTALLATION MANUAL V1.0321 This dash image is a visual representation for display purposes only. The information provided in this document is subject to change without notice due to changes and/or improvements to the product/s. www.topvehicletech.com...
  • Page 2: About This Product

    The KWSAA1 installation kit allows for the retention of the vehicle’s steering wheel controls and helps maintain the original aesthetic of the interior when installing a new car stereo. The KWSAA1 gives you everything you need for a complete install in one box. The components of this kit are compatible for the Saab 9-3 (2006-2012) with Fujitsu Ten factory stereos.
  • Page 3 FITTING GUIDE STEREO REMOVAL 1. Using a panel removal tool, begin to pry away the top and bottom lip of the air vents. Once loose, pull the air vents out of the dashboard. 2. Removal of the air vents will uncover 2x torx screws atop the radio, remove this and pull the radio out of the dashboard, disconnecting the wiring in the process.
  • Page 4 FITTING GUIDE STEREO INSTALLATION CONT’D. 6. When all the above wires (and any additional accessories) have been connected, finally make the connections between the stereo and the vehicles pre-existing connector. STEERING WHEEL CONTROL FUNCTIONALITY Please note: configuration layout may differ dependent on vehicle model. Original Button New Function 1.
  • Page 5: Wiring Diagram

    WIRING DIAGRAM ISO Amp Signal Attenuation Lead Connect between speaker ISO connector on harness and corresponding connector from new stereo (Optional: only needed if vehicle is amplified) Flying Wires Pink - Speed Pulse Green - Park Brake OEM Specific Connector [x2] Purple - Reverse Gear Connect to relevant connector from vehicle Blue- Amp Remote Turn On...
  • Page 6: Technical Assistance

    TECHNICAL ASSISTANCE If at any point you experience any problems and need any assistance before, during or after the installation process, please contact us via : Phone: 01420 470 605 E-Mail: help@topvehicletech.com Mon - Fri 9am - 5.30pm GMT If you would like to download a digital copy of this manual, or any other product, then please visit the www.topvehicletech.com website.

Table of Contents