Advertisement
Technical parameter Packing list
Technical parameter
Water-proof
Volume
Model
Grade
BRF1-80W
Antisplash
80L
PJF1-80W
BRF1-100W
100L
Antisplash
PJF1-100W
Model
Frequency
Rated voltage
220V~
BRF1-80W
50Hz
220V~
50Hz
PJF1-80W
220V~
50Hz
BRF1-100W
220V~
50Hz
PJF1-100W
Note: the above parameter errors ( except power value) of the lighting area are
volume errors are
3%, and the allowed error scope of other sizes is 10%.
Packing list
Packing method
Name of components
Water-storing tank
Tempreture and pressure valve
Safety valve
Exhaust valve
Large expanding bolt
Users manual
Packing container
o f w a t e r t a n k
1/2 Tee joint
Opposite wires S1/2F-3/4M
3/4
fiber spacer
Single-direction valve
Water pump joint 1
Water pump joint 2
Packing of pump
Screw nut
Rubber spacer
Pump
Packing of collector
Collector equipment
Note: accessories of BRF1-80/100W and PJF1-80/100W products are suitable only for
oblique installment. For flat installment, prop stand of different angles should be made
according to requirements, which is not included in the packing accessories.
¼ ¯ È È Æ ÷ ° ü × ° Ï ä
Rated internal
Size
Pressure
0.75MPa
482 524 875(mm)
482 524 1045(mm)
0.75MPa
Lighting area
Assistant power
2
1000W
1.50m
2
2.00m
1000W
2
1000W
2.03m
1000W
2
2.00m
Model
BRF1-120/150W PJF1-120/150W
1
1
1
1
4
1
1
4
4
1
1
1
1
2
1
1
3
Use methed
Press the setting key can set the following parameters: clock, preset time,
heating temperature, and temperature difference value of water pump
running. The number tube in the set parameter indicates glisteningly. To
press the adjusting Key
to the highest,press the setting key again,the number will increase
progressivelyfrom the minimal number.to continually press
one second, the adjusted parameter will increase progressively 3 numbers
every second setting of each parameter can be done by pressing the setting
key or by not pressing the setting key about 6 seconds. Then the system will
automatically confirm and automatically enter the next parameter setting,
until the system finally withdraws from the set conditions and returns to the
conditions of the previous clock. The set order of parameter in specific
modes is as follows:
Solar energy heating mode:
Indicating clock condition---to check the hour of clock---to check the minute
3%,
of clock---to set temperature difference of water pump running--- indicating
clock condition. For example: temperature difference value setting of water
pump running: to press the setting key to enter the setting condition of
temperature difference of water pump running. The indication board
indicates the present set value (the first place on the left of the clock number
tube indicates
approved set value, which is 15 ). To press the setting key to select between
15
and 10 . For the indication interface, see Fig.9.
to adjust numbers.when set the parameter up
L
, and the following two places indicate the tacitly
SOL H PRE INT
WT HC
T-DISP
SET
REG MODE
ON/OFF
Fig.10 Temperature setting interface for
The first time preset heating
12
more than
Advertisement
