Table of Contents
Summary of Contents for SUGA SWBGFSA-0
- Page 1 Suga Electronics Limited Model: SWBGFSA-0 WiFi/Bluetooth/GPS 3-in-1 Combo Module User Guide Version: 1.0 Jun 2014 © Suga Electronics Limited. All Rights Reserved. P. 1 Information in this document is subject to change without prior notice.
-
Page 2: Table Of Contents
Configuration for Wifi …………………………………………….. 3 Trouble-shooting …………………………..…….…….. 11 4 Disclaimer …………………………………..……...….. 13 5 Device Labelling …………………………….………….. 13 6 FCC Information …………………………….………….. 14 © Suga Electronics Limited. All Rights Reserved. P. 2 Information in this document is subject to change without prior notice. -
Page 3: Hardware Installation
UART_TXD, RXD UART data pins 17, 19 PMU_EN, LNA_EN System enable pins SYS_RST- System reset pin 20~22 IRQ_X Interrupt pins © Suga Electronics Limited. All Rights Reserved. P. 3 Information in this document is subject to change without prior notice. -
Page 4: Hardware Installation Procedures
6. Turn on the host unit and supply 3.3V+/-0.1V to the module. Figure 2. Example of module installation to the host system. © Suga Electronics Limited. All Rights Reserved. P. 4 Information in this document is subject to change without prior notice. -
Page 5: Software Installation
(5) Click Select > Select the patch file > Path. Wait until the log area reports successful. (6) Click BT or GPS to enable BT or GPS. (7) Read MAC address if necessary. © Suga Electronics Limited. All Rights Reserved. P. 5 Information in this document is subject to change without prior notice. - Page 6 Suga Electronics Limited © Suga Electronics Limited. All Rights Reserved. P. 6 Information in this document is subject to change without prior notice.
-
Page 7: Configuration For Gps
(2) Open “GPS MNL Decoder”. Select Set/Unset, Enable/Disable to enable/disable the GPS decoder. (3) Wait a few seconds. GPS data will be given out to the hyper-terminal. © Suga Electronics Limited. All Rights Reserved. P. 7 Information in this document is subject to change without prior notice. -
Page 8: Configuration For Bt
(1) Open “Lab Tool for Bluetooth V1.6”. (2) Fill in 32 to COM port. Select Open. (3) Configure BT package type, modulation, channel, etc. © Suga Electronics Limited. All Rights Reserved. P. 8 Information in this document is subject to change without prior notice. - Page 9 Suga Electronics Limited © Suga Electronics Limited. All Rights Reserved. P. 9 Information in this document is subject to change without prior notice.
-
Page 10: Configuration For Wifi
(1) Click Enable/Disable to enable/disable Wifi. (2) Confirm that the log area reported successful. (3) Configure desired channel, mode, etc. © Suga Electronics Limited. All Rights Reserved. P. 10 Information in this document is subject to change without prior notice. -
Page 11: Trouble-Shooting
(1) Under Windows, run Device Manager. Check the correct Physical COM port. Different computer has different COM port. (2) Check that Virtual COM installation is correct. © Suga Electronics Limited. All Rights Reserved. P. 11 Information in this document is subject to change without prior notice. - Page 12 (3) Check that there are 6 Virtual COM pairs installed as in below pictures. (4) Check that the Secure Digital Host Controllers is installed correctly. © Suga Electronics Limited. All Rights Reserved. P. 12 Information in this document is subject to change without prior notice.
-
Page 13: Disclaimer
Suga Electronics Limited 4. Disclaimer Suga Electronics Limited (SugaE) assumes no responsibility for errors or omissions in the materials available on this Document. THESE MATERIALS AND INFORMATION ARE PROVIDED “AS IS” WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESS OR IMPLIED , INCLUDING BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, OR NON-INFRINGEMENT. -
Page 14: Fcc Information
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. © Suga Electronics Limited. All Rights Reserved. P. 14 Information in this document is subject to change without prior notice.
Need help?
Do you have a question about the SWBGFSA-0 and is the answer not in the manual?
Questions and answers