Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Ubee DVW3201B
Summary of Contents for Ubee DVW3201B
- Page 1 U S E R ’ S M A N U A L DVW3201B...
-
Page 2: Table Of Contents
Content 1. Introduction ..........................3 1.1 Scope..........................4 1.2 Function..........................4 2 Product Specification ......................4 2.1 Hardware Specification....................4 3. Product Requirements......................5 3.1 Hardware Requirements....................5 3.2 Hardware Architecture ....................6 4 FCC Notice ..........................8... -
Page 3: Introduction
Section One: Introduction 1. Introduction Project Name: 802.11 a/b/g/n (2x2) card based on IC BCM43224 with BGA package. Product name:BCM3380Z D3.0 Wireless eMTA The typical use model for this embedded device is to allow the client device to be connected to an 802.11a/b/g/n 2x2 wireless network with infrastructure... -
Page 4: Scope
mode or to serve as an ad-hoc (peer-to-peer) data path. 1.1 Scope The Wireless BCM43224 is an available 11n solution in the 2.4/5GHz band, compatible with the IEEE802.11a/b/g/n. The 802.11 a/g data rate provides for 54, 48, 36, 24, 18, 12, 9, 6Mbps, and 802.11b data rate provides for 11, 5.5, 2, 1Mbps. -
Page 5: Product Requirements
Typical 15.5dBm(AV) for 11g Typical 14.5dBm(AV) for HT20 Typical 13.5dBm(AV) for HT40 Receiver Sensitivity Typical –65dBm for MCS15 (HT40) @ 10% PER Typical –67dBm for MCS14 (HT40) @ 10% PER Typical –68dBm for MCS13 (HT40) @ 10% PER Typical –71dBm for MCS12 (HT40) @ 10% PER Typical –73dBm for MCS11 (HT40) @ 10% PER Typical –76dBm for MCS10 (HT40) @ 10% PER Typical –79dBm for MCS9 (HT40) @ 10% PER... -
Page 6: Hardware Architecture
3.2 Hardware Architecture This specification describes an embedded 802.11a/b/g/n WiFi interface PCA ‘module’ for embedded device products. The module has two antennae. This module is powered from the host (3.3V) and interfaces to the host with PCIE-half signals. No switches, indicators or related user interface signals are provided on this module. -
Page 8: Fcc Notice
4 FCC Notice Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. - Page 9 Operations in the 5.15-5.25GHz band are restricted to indoor usage only IEEE 802.11b or 802.11g operation of this product in the U.S.A. is firmware-limited to channels 1 through 11. This device is intended only for OEM integrators under the following conditions: 1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna, 3) For all products market in US, OEM has to limit the operation channels in CH1 to CH11 for 2.4G...