Table of Contents
Advertisement
03
Connecting up
Chapter 3:
Connecting up
Important
• Before making or changing any connections, switch
off the power and disconnect the power cord from the
AC outlet.
About cable types
Analog audio cables
Use stereo RCA phono cables to connect analog audio
components. These cables are typically red and white,
and you should connect the red plugs to R (right)
terminals and white plugs to L (left) terminals.
Right (red)
Digital audio cables
Commercially available coaxial digital audio cables or
optical cables should be used to connect digital
components to this receiver.
Coaxial digital audio cable
• When connecting optical cables, be careful when
inserting the plug not to damage the shutter
protecting the optical socket.
• When storing optical cable, coil loosely. The cable
may be damaged if bent around sharp corners.
• You can also use a standard RCA video cable for
coaxial digital connections.
14
En
Analog audio cables
Left (white)
Optical cable
Video cables
Standard RCA video cables
These cables are the most common type of video
connection and should be used to connect to the
composite video terminals. They have yellow plugs to
distinguish them from cables for audio.
Standard RCA video cable
S-video cables
S-video cables give you clearer picture reproduction than
standard RCA video cables by sending separate signals
for the luminance and color.
Component video cables
Use component video cables to get the best possible
color reproduction of your video source. The color signal
of the TV is divided into the luminance (Y) signal and the
color (P
and P
) signals and then output. In this way,
B
R
interference between the signals is avoided.
Component video cables
Green (Y)
Blue (P
)
B
Red (P
)
R
Advertisement
Table of Contents
