Panasonic Quasar Omnivision PV-V4021-K Service Manual page 28

1. Installation of Top Cover
Install the Top Cover front portion at a downward angle so that the tab
on the Front Panel Ass'y fits into the hole in the Top Cover.
Then, lower the rear portion into place and tighten 2 Screws (S-1).
2. Installation of Front Panel Ass'y
CAUTION:
Opener Lever may be damaged when Front Panel Ass'y is installed,
with Cassette Door-Lid of Front Panel Ass'y and Opener Lever of
Cassette Up Ass'y set incorrectly.
A. When installing the Front Panel Ass'y, swing the Cassette Door-Lid
all the way open until the Cassette Door tab clears the Opener Lever.
B. Make sure that all locking tabs are aligned properly.
Then, press the Front Panel straight in.
3. Installation of VCR Chassis Unit
When installing 2 Screws (S-5), slide the Holder Unit of the Cassette
Up Ass'y (Refer to
MECHANISM" in Service Notes) to tighten screws. Then, slide it back
to the EJECT Position.
Make sure that Mechanism and Cassette Up Ass'y are in the EJECT
Position. (Refer to
ASSEMBLY PROCEDURES.)
4. Installation of Mechanism Chassis and Cassette Up Ass'y onto Main
Fig. D3
"METHOD FOR LOADING/UNLOADING OF
"EJECT Position
28
Confirmation" in DISASSEMBLY/