Siemens WK12D321EE Instruction Manual And Installation Instructions page 15

Special programmes
retirar pelusas/fios (Fluff Clean)
The drum must be empty.
This programme is designed to clean the drying cycle of any fluff
deposits. The washer-dryer uses the flashing symbol
cycle) in the display panel to show that this programme must be run. The
electronic cycle counter is then automatically reset. The
cycle) symbol goes out after the programme starts.
To run the retirar pelusas/fios (Fluff Clean) programme, proceed as
follows:
 Make sure that the drum is completely empty and close the door.
 Set the programme selector to retirar pelusas/fios (Fluff Clean).
 Press the inicio pausa (Start/Pause) button.
You can also run the retirar pelusas/fios (Fluff Clean) programme at any
time without prompting from the appliance.
'+centrigug.0 (Rinse + Spin)
An additional rinse cycle with a final spin. If the laundry is to be removed
dripping wet, set the spin speed to $ (Rinse stop) before starting the
programme → page 15.
+
+centrifug. 0 (Empty + Spin)
Drain the rinsing water following a programme with $ (Rinse stop)
→ page 15.
 Turn the programme selector to
 Set the spin speed to $ (Rinse stop).
 Press the inicio pausa (Start/Pause) button.
or
Drain and spin at the desired spin speed:
 Turn the programme selector to
 Press the 0 (Spin) button repeatedly until the desired spin speed is
set.
 Press the inicio pausa (Start/Pause) button.
(Fluff removal
7
7
:
:
+
+centrifug.0
(Empty + Spin).
+
+centrifug.0
(Empty + Spin).
(Fluff removal
14