Larson Electronics XLE-MD-DF-AD-LS-120V Instruction Manual

120V - Infrared Sensor, 1000mL Capacity - Universal Refillable
Thank you for your purchase of the Larson Electronics XLE-MD-DF-AD-LS-120V.
WARNING:
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
CRITICAL SAFETY INSTRUCTIONS:
INSTALLATION SHOULD ONLY BE CONDUCTED BY A QUALIFIED ELECTRICIAN IN ACCORDANCE WITH NEC AND ANY
•
RELEVANT LOCAL BUILDING CODES.
RISK OF FIRE OR ELECTRIC SHOCK. FIXTURE INSTALLATION REQUIRES KNOWLEDGE OF LUMINAIRES ELECTRICAL
•
SYSTEMS. IF NOT QUALIFIED, CONTACT A QUALIFIED ELECTRICIAN.
• BE CERTAIN ELECTRICAL POWER IS OFF BEFORE AND DURING INSTALLATION AND MAINTENANCE.
• MAKE SURE THE SUPPLY VOLTAGE IS THE SAME AS THE RATED LUMINAIRE FIXTURES VOLTAGE.
• TO PREVENT WIRING DAMAGE OR ABRASION, DO NOT EXPOSE WIRING TO EDGES OF SHEET METAL OR SHARP
OBJECTS. SUITABLE FOR DAMP LOCATIONS.
Infrared Warning
INFRARED LIGHT MAY CAUSE DAMAGE TO EYES IN VERY INTENSE CONCENTRATIONS.
RISK OF EYE DAMAGE AT SHORT DISTANCES. TURN LIGHT SOURCE OFF BEFORE SERVICING.
The XLE-MD-DF-AD-LS-120V from Larson Electronics is an Electric Automatic Soap Dispenser for no-contact hand
disinfection. This unit utilizes an infrared sensor to detect movement when dispensing soap. Equipped with a universal
refillable compartment for non-proprietary liquids, the device operates on 120V AC and can be mounted on walls.
BATTERIES AND AC CORD NOT INCLUDED.
MOUNTING
The automatic hand sanitizer dispenser is suitable for wall mounting applications.
INSTALLATION
When mounting and installing unit, make sure to keep at least 40 cm of free space below the unit.
1. Unlock and open the front cover, and remove the soap tank. (Pic A-1,2)
2. Make drilling marks and drill holes on the unit. Then insert the plastic plugs. (Pic A-3,4)
3. Fixate the dispenser onto the wall with screws. (Pic A-5)
4. Slide the lid of the battery box and load in four (4) C size batteries, or use an AC power cord for power instead. (Pic A-6)
a. AC power cord and batteries are not included with unit.
5. Insert the soap tank back into the unit. (Pic A-7)
6. Fill the soap tank with desired liquid. (Pic A-8)
Refer to pictures below for installation visuals.
Larson Electronics, LLC
Electric Automatic Soap Dispenser
Instruction Manual
A-5
Phone: (800) 369-6671
A-7
Fax: (903) 498-3364
XLE-MD-DF-AD-LS-120V
r : :
An-ti theft hole -......,
0
www.larsonelectronics.com
1 of 2