Advertisement
Electrical voltage and current
DANGER
Electrical voltage
Regularly check the electrical
equipment of the product.
Safety and protective functions
DANGER
Missing safety device and faulty
protective equipment.
Without protective equipment severe
injuries can occur, e.g. by taking hold of
the rotating equipment.
Electromagnetic radiation
Electromagnetic compatibility (EMC) may affect the system integration
of the product due to interaction.
Ensure the electromagnetic compatibility of the entire system.
Moving parts
DANGER
Self-starting product
If voltage is applied, the motor
automatically restarts after a mains
failure or when blocking has been
eliminated.
DANGER
Rotating impeller
Contact with the impeller may result in
injuries. Long hair, loose-fitting
garments and jewellery can be caught
and pulled into the product. Risk of
injury.
CAUTION
High risk of fire spreading
Can cause fire to spread.
Hot surface
Eliminate immediately loose
connections and defective cables.
Operate the product with protection
guards only.
Do not stand in the danger zone of
the product.
Switch off the mains voltage when
working on the product and secure
against switching on again.
Before starting the product, ensure
that it is securely fixed and that the
guards are in place.
Do not wear loose-fitting garments
or jewellery when working on
moving parts.
Protect long hair by wearing a hair
net.
Never direct the airflow
(intake/exhaust side) at a potential
source of fire.
Transport
Only transport the product in its original packaging. Secure during
transport.
The vibration values, temperature and climate ranges should not be
exceeded during transport.
Storage
Store the product in a dry and clean environment that is well protected.
Ensure that the storage temperature is adhered to,see Chapter 3,
Technical Data.If the product is not operated for a longer period of
time, we recommend running it for approx. 15 minutes annually to
move the motor bearings.
Cleaning
Disposal
When disposing of the product, observe all requirements and
regulations that are relevant in your country.
page 2 of 6
CAUTION
High temperature at motor housing.
Risk of burns
Provide adequate protection against
accidental contact.
NOTE
Product damaged during cleaning
Do not clean the product using a
water jet or pressure washer. Do
not put any pressure on the rotor.
Do not use cleaning agents
containing acids, caustic solutions
or solvents.
Advertisement
