Related Manuals for NELSEN WATER Signature Series
Summary of Contents for NELSEN WATER Signature Series
- Page 1 Signature Series Signature Series User Guide Twin Tank Single Tank Softeners & Filters 1", 1-1/4", 1-1/2", 2" & Twin Control Valves...
- Page 2 “DELAYED RINSE+FILL” is displayed whenever a zero-capacity tank has transferred to an off-line state and is currently waiting to initiate the second portion of a regeneration cycle. Viewed only when Delayed Rinse and Fill is set to ON. Nelsen Water Solutions User Guide...
- Page 3 If a power outage lasts less than 8 hours and the time of day flashes on and off, the time of day should be reset and the battery replaced. Nelsen Water Solutions 1", 1¼", 1½", 2" & Twin Control Valves...
- Page 4 Installer control is set for time-clock Level. Steps 7IL & 8IL. operation. User 3 REGENERATION IN 14 DAYS Displays number of days to next regeneration. Not shown when day override set to off. Nelsen Water Solutions User Guide...
- Page 5 Brine Valve Brine Tank Air Check Brine Distributor Tank Basket Air Check Distributor Basket Air Injection Oxidation (AIO) Filter System Control Valve Air Pocket Distributor Tube Filter Media Distributor Basket Nelsen Water Solutions 1", 1¼", 1½", 2" & Twin Control Valves...
- Page 6 It is recommended to periodically clean the brine tank no matter what salt you use. REMEMBER: Salt is the fuel to run your water conditioner. Buy the best clean salt available. Nelsen Water Solutions User Guide...
- Page 7 6. Reset the time of day (see programming procedures) and initiate regeneration (see operating displays and maintenance). Please consult the installing dealer for service if these procedures do not remedy the problem. Nelsen Water Solutions 1", 1¼", 1½", 2" & Twin Control Valves...
- Page 8 6 hrs. old). This portion of memory includes parameters normally displayed in the diagnostic branch of the menu map. Configurator file downloaded to the control was not originally uploaded from CONFIG DOWNLOAD another control with the identical software revision Nelsen Water Solutions User Guide...
- Page 9 Verify meter cable wires are installed securely into three pressed and held three pin connector pin connector labeled METER Defective meter Replace meter Defective PC Board Replace PC Board Nelsen Water Solutions 1", 1¼", 1½", 2" & Twin Control Valves...
- Page 10 Power outage during regeneration maining regeneration time. Reset time of day Damaged seal/stack assembly Replace seal/stack assembly Water running to drain Piston assembly failure Replace piston assembly Drive cap assembly not tightened properly Re-tighten the drive cap assembly Nelsen Water Solutions User Guide...
- Page 11 Products or parts therein must be returned to Nelsen’s authorized dealer at Buyer’s cost. Any replaced Products, or any parts therein, shall be retained by and become the property of Nelsen. If Nelsen determines that the repair or replacement of the Product or part Continued Next Page Nelsen Water Solutions 1", 1¼", 1½", 2" & Twin Control Valves...
- Page 12 Limited Warranty therein is not commercially practicable, Nelsen will issue a credit in favor of Buyer in an amount not to exceed the purchase price of the Product. Notwithstanding anything to the contrary herein, this Limited Warranty does not cover any cost or labor associated with the removal or re-installation of the replacement Product or part therein or any shipping costs associated with the returned Product or part therein, which remains the sole cost, risk and responsibility of Buyer, unless otherwise agreed in writing by Nelsen.