parking solutions and MTAG2 for mounting on metal.
These tags operate with IR 8000 and IR 8000 w readers.
WSTag is designed for installation on the windshield inside
the car. The long reading distance of this passive tag makes
it ideal for parking solutions and vehicle identification.
MTag2 can be installed on metal surface by using screws
and without any kind of isolation. This tag is ideal for asset
tracking like identification of railway wagons, containers
etc.
Specifications
Carrier frequency
Size (hxwxd)
Chip
Operating distance
Material of housing
User memory size
System memory size
Supported ID structures
Installation
Installation method
Applications
Colour
Temperature range
Operational (without programming)
Operational (programmed)
Storage
Protection class
Idesco Oy reserves the right to revise this publication and to make changes to its content as well as the right to change or discontinue these products, at any time, without obligation to
notify any person or entity of such revisions or changes. All trademarks and registered trademarks are property of their respective owners. Printed in Finland 3/2005
Page 1
IP64 Idesco Oy reserves the right to revise this publication and to make changes to its content as well as the right to change or discontinue these products, at any time, without obligation to notify any person or entity of such revisions or changes. All trademarks and registered trademarks are property of their respective owners. Printed in Finland 3/2005...
Page 2
Installation instructions WSTag and MTag2 Installation of MTag2 MTag2 is installed directly to metal surface without insulation. The sticker side must be against the metal surface. Use two 4mm screws. MTag2 should be installed in the same polarization as the reader antenna.