QUICK START
COMBI-HEATER
CONTROLLER
1. DISPLAY LAYOUT
2
3
4
7
1 – Status bar; 2 – Settings bar; 3 – Time display;
4 – Menu bar; 5 – AC line icon; 6 – Temp. display;
7 – Return button; 8 – Rotary pushbutton.
Navigation through the menus and value adjustments
are all done by the means of rotary pushbutton (8) and
return button (7) on the front panel of the controller.
Pressing rotary pushbutton is equal to [Enter]
command, rotating pushbutton is equal to [+]/[-],
up/down or left/right..
2. POWER UP
After device is turned ON, an "INIT.." message should
appear on the screen. Few seconds later it changes to
time display.
3. SETTING TIME
GUIDE
Press the rotary pushbutton
[Enter] to bring up the menu.
First icon begins to flash
[<] and [>] to select the clock icon
1
[<] and [>] to enter the time. Press
[Enter] to navigate between
6
5
8
4. SETTING INDOOR AIRFLOW AND
TEMPERATURE
Press the rotary pushbutton
[Enter] to bring up the menu
and rotate the knob to navigate
to RV icon, then press [Enter]
First icon begins to flash.
Rotate the knob to select the temperature (between 5°C
Flame icon will appear in the top left corner to indicate
that the heating cycle has started. The heating cycle will
Press [Return] button to return to main menu.
NOTE: Setting higher setpoint will not increase amount
Rotate the button
and press [Enter].
Rotate the button
segments.
and 30 °C) or OFF, then press [Enter].
continue until the setpoint was reached.
of produced heat, use fan speed instead.
To adjust the fan speed scroll to
the fan icon and press [Enter].
Select desired volume:
[VENT], [ECO], [LOW], [HIGH],
[BOOST] or [OFF] and press
[Enter]
Setting higher fan speed will increase amount of produced
heat and will heat room faster, setting lower fan speed will
decrease amount of heat.
Press [Enter] to go save and go back to main menu.
5. SETTING WATER TEMPERATURE
Using [<] and [>] keys,
navigate to Thermometer
Icon and press [Enter].
OFF
Water heater is turned off.
ECO
Temperature target is 40°C/104°F
HOT
Temperature target is 60°C / 140°F
BOOST Only heats the water for 40 minutes or until
the water temperature reaches 60°C / 140°F.