LUCOLED Lucoflex Installation Manual

Lucoflex
INSTALLATION GUIDE
Welcome to Lucoflex Lighting
Lucoflex Lighting is easy to install in straight, horizontal curved spaces where humidity or outdoor conditions.
It's creates hot-pot free, smooth, warm and relaxing environments or delivers bright task lighting.
Please read these guidelines completely before installing.
It is important to read these guidelines completely to understand how it can be configured, cut to size, re-connected, and installed
so you can design your LED lighting layout.
NEVER attempt any work without shutting off the electricity.
Use only with low voltage 24V DC power source
Do not stare directly into the LED lights when illuminated
Do not power LED tape while coiled on reel
Always observe polarity for connections, positive (+) to positive and negative (–) to negative
To be installed by a qualified electrician.
Keep away from combustible materials such as plastic or paper products.
All wiring must be in accordance with national and local electrical codes, low voltage Class 2 circuit.
If you are unclear as to how to install and wire this product, contact a qualified professional.

Unpacking

Rolling the wheel when you unpacking the light.
Warning: Do NOT shake the light!
Do NOT pull the light from the wheel straightly.
Min:
Φ50mm
[1.97]

Bending

Lucoflex can only be bent laterally
(opposite bent along to light surface).
Do not bend smaller than allowed min bend dia.
The electrical circuit or LED chips could be damaged if bending
diameter is too small.
WET
LOCATION
No Twisting
Lucoflex is NOT allow to twisted in any conditions. The electrical circuit or
LED chips could be damaged with this action.
Horizontal line
Incorrect Bending
Horizontal line
Lucoflex is NOT allow to bending in up and down way.
The bending as photos show will damage the electrical circuit or LED chips
damaged seriously by this incorrect action.
DC
ONLY
Horizontal line
1