KATEK T.200.001.589 Instructions

Pull Cord Set
for N86
T.200.001.589
This package contains
all the necessary parts
to add to an N86 trans-
mitter the possibility to
trigger an alarm using a
pull cord.
This kit cannot be ins-
talled in a N46 trans-
mitter.
Disassemble the device :
1. Remove the battery trap
2. Remove the battery
3. Remove the 4 screws
4. Remove the bottom housing
5. Remove the PCB
WARNING !
The N86 should be opened in an ESD pro-
tected environment with respect to the
necessary precautions : discharge your-
self from electrostatic loads by touching a
grounded conductive surface before opening the unit.
3
1
The package contains the following items :
2 x Press-fit nuts M3
1 x Wire 60 mm
1 x Wire 40 mm
Pull switch with
break-away part
1
2
Prepare the switch :
1. Insert the 40 mm wire into the switch contact
2. Insert the 60 mm wire into the switch contact
3. Put the screws M3 into the holes of the switch
2 x Screws M3
1 x 2m cord with break-
away part and cone
New special
battery trap
3
2
1