Advertisement
EEVA WALL BASIN/BATH SETS
EEVA WALL BASIN/BATH SET BACKPLATE – RIGHT HAND
SPECIAL NOTE
Please note that this product has been assembled as a WALL BASIN SET with a 6 litres / min flow regulator
For applications where the flow regulator is not required e.g. BATH, a full flow aerator insert has been supplied
in this box
BRICK VENEER – TIMBER NOGGIN INSTALLATION
Diagram #1
Mark desired position of wall set and fit screw on left hand side of BODY ASSEMBLY
Diagram #2
With the DOTTED LINE on the wall mixer cover at the 12 O'CLOCK POSITION, use levelling
tool as shown and mark the right-hand side screw hole
Diagram #3
Fit all other screws – re-check level
BRICK MASONRY INSTALLATION
Diagram #1
Fix wall set to brickwork with self-tapping screw in 5mm drilled hole
Diagram #2
With the DOTTED LINE on the wall mixer cover at the 12 O'CLOCK POSITION, use levelling
tool as shown and mark the right-hand side 5mm screw hole
Diagram #3
Fit self-tapping screw on right hand side – check level – additional screws not necessary
Assembly is ready to be cemented in position
During cementing, check alignment with levelling tool
FREECALL: 1800 800 919
For all servicing needs, please contact CUSTOMER SERVICE on:
PHONE: 08 6217 0600
FAX: 08 6217 0699
www.aldertapware.com.au
CUTTER
REQUIRED
EMAIL: customer.service@aldertapware.com.au
NIPPLE
V191007
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Alder EEVA Series
- Page 1 EEVA WALL BASIN/BATH SETS EEVA WALL BASIN/BATH SET BACKPLATE – RIGHT HAND SPECIAL NOTE Please note that this product has been assembled as a WALL BASIN SET with a 6 litres / min flow regulator For applications where the flow regulator is not required e.g. BATH, a full flow aerator insert has been supplied in this box NIPPLE CUTTER...
- Page 2 GENERAL FOR TIMBER NOGIN & BRICK MASONRY Diagram #4 Remove PLASTIC GUIDE to complete tiling Diagram #5 After tiling, push 5MM PLASTIC SPACER over 19BP Elbow (5mm PLASTIC SPACER can be found in rear of WALL PLATE) – use NIPPLE CUTTER* (see below) to reduce length of 19BP Elbow to a 5MM PROTRUSION FROM THE TILE FACE Diagram #6 Remove 5MM PLASTIC SPACER and assemble CONNECTOR onto the 19BP Elbow –...
Need help?
Do you have a question about the EEVA Series and is the answer not in the manual?
Questions and answers