Geotab Go7 Installation Manual page 4

This vehicle specific technical installation information sheet must only be used with the GO device installation manual

(

h ttps://goo.gl/rkLRiA

) and is only for use by Geotab Authorised Installers. It is based on Geotab's suggested best practice, valid

at time of publishing. There may be differences or revisions between specific vehicle models, trim-levels, equipment or accessories

made by the vehicle manufacturer and these are beyond Geotab's control.

To ensure you have the latest available version of this document, or if you require any assistance please contact your Authorised

Reseller before proceeding with the installation.

_____________________________________________________________________________________________________________________________

TM denotes a trademark of Geotab Inc., which may be registered in certain countries

Secure the Geotab unit to a suitable bracket

inside the dashboard, using at least two

cable-ties.

Ensure that the harness does not obstruct any

moving parts or equipment

Finally, replace all panels, screws and clips in the

reverse order they were removed

The GPS-antenna is located at the "underside" of

the Geotab device. Take care when securing the

device into the vehicle, that this side is facing

away from any metal surface

Finally, replace all panels, screws and clips in the

reverse order they were removed

Start the engine, leaving it to idle. All three

LED's will flash red briefly - wait until you see all

three LED's: Red (Power), Green (GSM) and Blue

(GPS). These tell you the unit has connected

successfully.

During this five-minute process the unit will also

beep repeatedly as it updates to the latest

settings.

Log on to:

h ttps://installmygps.com

Enter your details including the serial number of

the Geotab device. Select " L og Install " and wait

for the green notification of a successful

installation.