Hausler 450 SE V2 RTF Quick Start

HAUSLER 450 SE V2 RTF (Ready-To-Fly)
• 450 Size RC Helicopters use Lithium Polymer batteries (lipos).
• DO NOT leave your batteries unattended while they are being charged.
• You must have a fresh charge on your battery before you fly your 450.
Getting your HAUSLER 450 SE V2 RTF ready
Note: The manual shows an optional AC adapter for charging. All helicopters
come with a 12v charger so you can do a mobile charge from any 12V source.
Your transmitter is configured for Mode 2 – the cyclic is on the right stick, the
rudder and throttle on the left. RTF version comes with a 2.4 gHz digital six
channels radio system with Normal mode and one programmable flight mode for
full 3D/Stunt capability.
• You need 8 AA batteries (not included) for the your transmitter
• Remove the battery and the battery charger from the packaging.
• The battery has two leads, a "T" plug and a balance plug with multiple colored
wires. Plug the balance plug into your charger and connect to a 12v source.
It is normal for the charger to be warm. Periodically remove the battery from
the charger during the charge to let the charger voltage readjust.
• The three lights are red when the battery is discharged, and will go green
when the battery is fully charged. The charge rate is 1.2 amps, which will
take about 1 ½ hours to reach full charge.
• You will get 5 – 6 minutes of flight time per charge. Do not try for longer flight
times as it can damage the battery.
1. USB connection – transmitter to computer
2. Set up CD (for setting up flight modes)
3. Bind plug
4. Canopy grommets
5. Sticky tape and straps
6. Extra rubber stoppers for landing gear
READ THIS FIRST!!!
Quick Start
Important Safety Notices
Included Accessories