Advertisement
STARTING UP LINE 1
If you are not on the master screen (as shown above), press the "Return" button continually until you see
the master screen.
1. Press the "Menu/Select" button.
2. With the cursor flashing on "properties" press the "Enter" button.
3. With the cursor flashing on "line 1" press the "Enter" button. You should see the following screen:
4. Press "Enter" again and the screen should display "auto", "stop", and "inactive". Use the arrow key
to highlight "auto" and press "Enter."
5. Now press the "Return" button three times to return to the master screen.
6. At this point, the Master Controller should start sending time signals to the clocks and the hands
should start moving. The clocks will usually stop at 12 o'clock, 4 o'clock, 8 o'clock. After a while,
they should start moving again. Eventually they will stop on the correct time and resume normal
operation.
© 2016
HERTZ ELECTRONICS
... over ...
Advertisement
