Table of Contents
Advertisement
8
Connect the wires from your left channel loudspeaker to the left positive and negative terminals and the wires from the right channel loudspeaker to the
right positive and negative terminals.
In each case, the red terminal is the positive output and the black terminal is the negative output.
Care should be taken to ensure no stray strands of wire short the speaker outputs together. Please ensure that the loudspeaker terminals have been
tightened completely to provide a good electrical connection.
It is possible for the sound quality to be affected if the screw terminals are loose.
4. LOOP OUT - This output can be used for bi-amping, daisy chaining or connecting to the input of an active subwoofer.
The XLR output is balanced and the RCA output is unbalanced.
5. BALANCED/UNBALANCED SWITCH - Select depending on whether a source is connected to the balanced XLR or unbalanced RCA input.
Note: There will be no sound from the amp if the correct input isn't selected. If a source is connected to the balanced input, for example, ensure that the
balanced switch has been selected.
6. BALANCED/UNBALANCED INPUTS - The XLR input is balanced and the RCA input is unbalanced.
7. AUTO POWER DOWN (APD) SWITCH - Switches to enable or disable the Auto Power Down function. When enabled, the amplifier will automatically
switch to standby mode after inactivity of 20 minutes.
8. LINK - Refer to the 'Power syncing' section of this manual for more information.
Advertisement
Table of Contents
