Ortech SLIM4DGR-5CCT Instruction Manual

LED Slim Lights
MODEL SLIM4DGR-5CCT
1. For your safety, this fixture MUST be wired in accordance to local electrical codes and ordinances
2. Turn power off from the electrical panel before starting installation or attempting any maintenance. Indoor installation only
CAUTION
PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCES.
Electrical products can cause death or injury, or damage to property.
If in any doubt about the installation or use of this product, consult a competent electrician.
INSTALLATION GUIDE
Tools Required
• Saw
• Measuring Tape
• Electrical Wiring (use type and gauge suitable for
application to connect the fixtures)
Driver Wiring
1. Open the hardwire box swing cover and remove the
appropriate knockout(s)
2. Insert the electrical supply cable through the knockout
and secure with a cable connector (sold separately)
3. Using wire nuts, connect GREEN ground wire of cable to
GREEN wire on box. Connect WHITE wire of cable to
WHITE wire of box. Connect BLACK wire of cable to BLACK
wire of box (see Fig.1)
4. Place all wiring and connections back into the box and
close the cover
5. Insert hardwire box through the mounting hole (see Fig.2).
New Construction Applications:
Hardwire box shall be firmly secured to studs, joists, or
similar fixed structural units
Remodel Applications:
DO NOT require the hardwire box to be firmly secured
after the mounting plates, studs, joists, or structural units
have been concealed
info@ortechindustries.com
www.ortechindustries.com
WARNING
WARNING — THE INSTALLATION MUST BE CARRIED OUT BY A QUALIFIED ELECTRICIAN.
1. LED Slim Lights are suitable for indoor use only. DO NOT use outdoors
2. Please keep the LED Slim Lights away from any corrosive substance,
and please use dry cloth when you clean them
3. LED Slim Lights can only be installed by a qualified electrician
4. Before installation or maintenance, please disconnect the power to prevent electric shock
Application Notice
Pre-installation
1. Turn power OFF from the electrical panel before starting installation
2. Locate a suitable position to plate the fixture and open in
3. Run electrical wire from the switch (power supply) through the
13376 Comber Way
Surrey BC V3W 5V9
accordance to the cut-hole dimensions
mounting hole — use NMD90 Romex or BX cable
Power supply
White
Wire
Cable to
fixture
Yellow-
green wire
375 Admiral Blvd
Mississauga ,
ON L5T 2N1
Instruction Manual
Fig.1
Black
wire
Fig.2
1-888-543-6473
1-888-541-6474