Electrolux CIS64383 User Manual page 21

Problem
The display does not react
to the touch.
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactiva‐
ted.
The hob deactivates.
Residual heat indicator
does not come on.
You cannot activate the
highest heat setting.
The sensor fields become
hot.
Hob²Hood does not work.
Hob²Hood operates, but
only the light is on.
Possible cause
You do not set the heat
setting for 60 seconds.
You touched 2 or more
sensor fields at the same
time.
Pause operates.
Part of the display is cov‐
ered or the pots are placed
too near to the display.
There is some liquid or an
object on the display.
You put something on one
or more sensor fields.
You put something on the
sensor field .
The zone is not hot be‐
cause it operated only for a
short time or the sensor
under the hob surface is
damaged.
Another zone is already
set to the highest heat set‐
ting.
The Power limitation level
is too low.
The cookware is too large
or you put it too near to the
controls.
You covered the control
panel.
You activated the H1
mode.
ENGLISH
Remedy
Activate the hob again and
set the heat setting in less
than 60 seconds.
Touch only one sensor
field.
Refer to "Daily use".
Remove the objects. Move
the pots away from the dis‐
play.
Clean the display, wait un‐
til the appliance is cold.
Disconnect the hob from
the electrical supply. After
1 min, connect the hob
again.
Remove the object from
the sensor fields.
Remove the object from
the sensor field.
If the zone operated suffi‐
ciently long to be hot,
speak to an Authorised
Service Centre.
First reduce the power of
the other zone.
Change the maximum
power in the Menu. Refer
to "Daily use".
Put large cookware on the
rear zones if possible.
Remove the object from
the control panel.
Change the mode to H2 -
H6 or wait until the auto‐
matic mode starts.
21