Advertisement
How to Use
INSTALLATION
1. To level your refrigerator, you may either turn the level leg clockwise to raise that
side of the refrigerator, or turn counter-clockwise to lower that side. Having
someone push against the top of the refrigerator will take some weight off the
leveling leg. This makes it easier to adjust the leveling leg. If the refrigerator is
not leveled during installation, the doors may not close or seal properly, causing
cooling, frost, or moisture problems. It is very important for the refrigerator to be
level in order to function properly.
2. Place refrigerator approximately 5 inches from the wall to ensure proper airflow
to the compressor. Do not place refrigerator near any heat sources such as a
heater or stove.
3. This refrigerator requires a 110V-120V, 60Hz power supply.
REVERSING THE DOOR POSITION (see diagram on page 7)
Tools required: phillips screwdriver and 10mm socket screwdriver.
To reverse the door, it is necessary to tilt the appliance backward. You should rest
the appliance on something solid (like a chair), just below the top panel. We
recommend you have someone to assist you. DO NOT lay the appliance
completely flat, as this may damage the coolant system.
1. Ensure the appliance is unplugged and empty. Adjust the two leveling feet to
their highest position.
2. Remove the upper hinge cover, then unscrew the screws of the upper hinge
bracket and take off the hinge.
3. Take off the left side screw covers. Pull the appliance door up and off.
4. Remove the leveling feet.
5. Remove the bottom hinge bracket by unscrewing the mounting screws, and
install it on the opposite side of the refrigerator.
6. Install the leveling feet and tighten the bottom hinge bracket.
7. Slide the door on to the bottom hinge pin. Replace the upper hinge bracket on
the new side and check that the door swings smoothly. Ensure the seals close
tightly on all sides before tightening the upper hinge bracket.
8. Replace the hinge cover and tighten the screws. Replace the screw covers on
the opposite side.
9. Readjust the leveling feet.
6
Wards.com
How to Use
Upper Hinge Bracket
Screw Covers (3)
Bottom Hinge Bracket
1
888
557
3848
•
•
•
7
Advertisement
