Table of Contents
Advertisement
Troubleshooting (cont.)
Problem
Possible Cause
Washer will not turn
Cord is not plugged in.
on
Circuit breaker has
tripped or house fuse is
blown.
Poor stain removal
Previously set stains.
Water leaks every
Hoses not installed cor-
load
rectly.
Washer will not
Kinked drain hose.
drain water
Drain hose located
higher than 48". above
the floor.
16
Solutions
Check that plug is secure into
outlet.
Reset circuit breaker or re-
place fuse.
Articles that have previously
been washed may have stains
that have been set. These
stains may be difficult to re-
move and may require hand
washing or pre-treating to
aid in stain removal.
Check that all hoses are
installed correctly and that
hose connections are tight
and secure.
Ensure that the drain hose is
not kinked.
Make sure the drain hose is
no higher than 48" above the
bottom of the washer and is
no more than 60" away from
the washer.
Wards.com
Troubleshooting (cont.)
Problem
Possible Cause
Washer will not
Water supply is turned
operate
off.
Control panel has pow-
ered off due to inactivity.
Washer is unplugged.
Lid is open.
Circuit breaker/fuse is
tripped/blown.
START/PAUSE was not
pressed after a cycle was
set.
Extremely low water
pressure.
Washer is too cold.
Washer is running under
Delay start program.
Solutions
Turn on the water.
Press ON/OFF to turn on.
Ensure cord is plugged in.
Close the lid and press
START/PAUSE.
Check house circuit breakers/
fuses. The washer should be
on a dedicated circuit.
Reset and press START/
PAUSE.
Check another faucet in the
house to ensure water pres-
sure is adequate.
The display will not come on if
the washer has been exposed
to below freezing tempera-
tures. Let the washer come to
room temperature, then try
again.
It will start automatically after
the delay time has elapsed.
1
888
557
3848
•
•
•
17
Advertisement
Table of Contents
