Radiant TS8100-TIM-H Instructions

Radiant Australia Pty Ltd Unit 1 / 18 Profit Pass, Wangara, WA 6065
Telephone: 08 9302 4140 Fax: 08 8490 2343 Email: orders@radiant.com.au
TS8100 - TIM - H TIMER INSTRUCTIONS
LCD SYMBOLS
LCD Symbols
Symbols Description
Turning on/o the timer
The buttons are locked
Manual mode
AUTO Automatic mode, executes the programmed schedules
CONFIGURATION MENU
Con guration Menu
To enter into menu settings, touch
Then you will see menu 01. Touch
Features description
Menu #
01 Backlight turning-on time
02 Clock format
03 5+2 /7 Day program mode
SETTING THE CLOCK + DAY OF THE WEEK
Setting the clock and day of the week
This timer is tted with a real time clock. It is essential that the clock time and day are set accurately if you require your programmed events to start on time. Follow below steps,
1) Touch time display . Use or
2) Touch day display . Use or
SELECT THE REQUIRED OPERATING MODE
Select the required operating mode
Auto - Automatic mode, the timer executes the preprogrammed schedules. To adjust these schedules, see page 2 the program section.
In addition to Automatic mode, this thermostat has a manual modes. The manual mode maintains a constant on or o status set by the user.
To change the ON/OFF status, touch ON /OFF display area. Use
TS8100-TIM-H Programmable Timer
to turn timer o , and now touch
Next or Previous to select the menu number. Use
Features Explanation
To set the backlight turning-on time when the screen is pressed.
12 Hour or 24 Hour clock format selection
This allows you to program either 5 days at once, then the 2 days of the weekend
separately, or a full 7 days at the same time or 7 days separately
to change the time. Press and hold
to change the day. Touch
Done
or
Symbols Description
Day of the week. Day 1= Monday, Day 2= Tuesday... etc.
Day
Program 1,2,3,4 The program number
O / RIDE Temporary override your program
Set Menu
or adjust the settings. Touch
or to change the time faster. Touch
to store and exit.(or touch Day display to cancel and exit).
to adjust. Touch to store and exit.
Done
ver 1.1
to accept and store.
Done
Touch or
10, 20,30,40,50,60 seconds. 30 seconds by default
24H / 12H 24 hour clock by default
5 2 = 5+2 day programmable
7 = 7 day programmable (by default)
Done to store and exit( or touch time display to cancel and exit).
See overleaf for further instructions >>>
to adjust