Lumineux Sutton Batten Installation Instructions

Sutton
Batten
Single & Twin
1

READ THESE INSTRUCTIONS

THOROUGHLY BEFORE
INSTALLATION KEEP THESE
INSTRUCTIONS FOR
FUTURE REFERENCE.
IMPORTANT:
This product must be installed
by a qualifi ed electrician or
competent person, and in
accordance with current building
and IET wiring regulations.

BOX CONTENTS

This lighting fi xture has been properly
packed to avoid damage during
transit. Before commencing with the
installation carefully inspect the
4
luminaire to confi rm there is no
damage. DO NOT INSTALL if any
damage has occurred to the fi xture
or any of its components.
NON– EMERGENCY FITTINGS
• Light Fitting
NON– EMERGENCY FITTINGS
• Instruction Manual
CLASS I PRODUCT
CLASS I PRODUCT

Electrical connection wiring

EARTH CONNECTION
EARTH CONNECTION
REQUIRED. REQUIRED.
NON– EMERGENCY FITTINGS

TOOLS REQUIRED

• Drill

Product Specification:

Product Specification:
NON– EMERGENCY FITTINGS
Unit
Unit CLASS I PRODUCT
NON– EMERGENCY FITTINGS
EARTH CONNECTION
4ft Single 220-240VAC, 50/60Hz
4ft Single 220-240VAC, 50/60Hz
CLASS I PRODUCT
• Screwdriver
4ft Twin
EARTH CONNECTION
4ft Twin Product Specification:
REQUIRED.
5ft Single 220-240VAC, 50/60Hz
5ft Single 220-240VAC, 50/60Hz
Unit
• Cable
5ft Twin
5ft Twin
Product Specification:
4ft Single 220-240VAC, 50/60Hz
6ft Single 220-240VAC, 50/60Hz
6ft Single 220-240VAC, 50/60Hz
Product Specification:
Unit 4ft Twin
6ft Twin
6ft Twin
A
E E Manby Business Park, Manby, Lincolnshire, LN11 8UT
4ft Single 220-240VAC, 50/60Hz
5ft Single 220-240VAC, 50/60Hz
Unit
Lumineux is a B&T Associates Ltd company.
G
4ft Twin
4ft Single 220-240VAC, 50/60Hz
5ft Twin
INSTALLATION INSTRUCTIONS
2
on
off
LIVE = Brown
LIVE = Brown
5
NEUTRAL = Blue
NEUTRAL = Blue
GND = Green/Yellow
LIVE = Brown
GND = Green/Yellow
NEUTRAL = Blue
GND = Green/Yellow
LIVE = Brown
NEUTRAL = Blue
LIVE = Brown
NEUTRAL = Blue
GND = Green/Yellow
NEUTRAL = Blue
CLASS I PRODUCT EARTH = Green/Yellow
GND = Green/Yellow
EARTH CONNECTION
LIVE (SW) = Brown
REQUIRED.
Input Voltage Wattage Length Width Height LF(mm)
Input Voltage Wattage Length Width Height LF(mm)
19W 1220
19W 1220
REQUIRED.
220-240VAC, 50/60Hz 38W 1220
220-240VAC, 50/60Hz 38W 1220
27W 1524
27W 1524
Input Voltage Wattage Length Width Height LF(mm)
220-240VAC, 50/60Hz 50W 1524
220-240VAC, 50/60Hz 50W 1524
19W
38W 1829
38W 1829
Input Voltage 220-240VAC, 50/60Hz Wattage Length Width Height LF(mm) 38W
220-240VAC, 50/60Hz 60W 1829
220-240VAC, 50/60Hz 60W 1829
19W
27W
Input Voltage Wattage Length Width Height LF(mm)
220-240VAC, 50/60Hz 38W
19W 1220
220-240VAC, 50/60Hz 50W
19W, 27W & 38W Single / 38W, 50W & 60W Twin
50,000
IP20
Hours
3
6
64 62 1016
64 62 1016
64 62 1016
64 62 1016
64 62 1320
64 62 1320
64 62 1320
64 62 1320
1220 64 62 1016
64 62 1625
64 62 1625
1220 64 62 1016
64 62 1625
64 62 1625
1220 64 62 1016
1524 64 62 1320
Technical Helpline: +44 (0)1507 328031
1220 64 62 1016
64 62 1016
1524 64 62 1320
Sutton
5 YR
Warranty
BESA
PLEASE READ THESE INSTRUCTIONS
• Turn off the mains power before performing
inspections, installation, or removal
• Verify that the supply voltage is correct by
comparing it with the luminaire label information
• It is the installers responsibility to ensure installation
is suitable for the total load of the luminaire(s). The
supply cable, fuses/circuit brakers must be correctly
rated for the electrical load and considering for any
transient inrush currents that may occur
• Do not perform insulation strength or resistance
tests on installed luminarie(s) connected
1. Route the correct 3-core or 4-core cable type
on
according to the location of the light fi tting
2. Secure the supplied wall plugs to the surface
where you want to mount (1)
off
3. Separate the body from the diffuser (2)
4. Secure the base of the fi ttting to the wall or ceiling
5. Feed the cable through the entry point and wire
into the terminal block (4)
6. Re-fi t the diffuser and screw in the remaining
retaining screws (6)
7. Switch the mains power on and check the light
fi tting illuminates
BEFORE INSTALLATION.
WARNING: Risk of electric shock! Isolate
the mains power before proceeding.
www.lumineux.co.uk