Summary of Contents for Carimali A01-PLUS -V2
- Page 1 ENGLISH ENGLISH LB.05073 73.04.EN EDITION EDITION SEPTEMBER 2014 www.carimali.com...
-
Page 2: Table Of Contents
Sommario INTRODUCTION ................................ 3 SPECIAL NOTES................................. 3 TECHNICAL DATA ..............................4 POTENTIAL – EQUALIZING CONNECTION......................5 ASSEMBLY AND ELECTRICAL CONNECTIONS ....................6 STARTING UP ................................8 MILK TANK FILLING ..............................9 CLEANING ................................10 TROUBLE SHOOTING ............................. 11 PRESET FRIDGE CONFIGURATION ........................13 LEGEND.................................. -
Page 3: Introduction
INTRODUCTION Thoroughly read the instructions contained in this booklet because it gives important information regarding safety for installation, use and maintenance. Keep this booklet in a safe and accessible place for further consultation. After unpacking check that the machine is not damaged. If in doubt, do not use the machine and contact an Authorised Service Centre. -
Page 4: Technical Data
TECHNICAL DATA Model Width Height Depth Net weight Cold Room capacity 11,8 Cold Room data Gas type R134a Gas Quantity - g Compressor Name PL35G Climatic class Pressure LP= 2,5 bar / HP= 14bar Electical data 100-120V @ 50/60Hz 200V @ 50/60Hz 220-240V @ 50/60Hz Power Measured noise... -
Page 5: Potential - Equalizing Connection
POTENTIAL – EQUALIZING CONNECTION ITALIANO Questo collegamento previsto da alcune normative di sicurezza, ha la funzione di evitare le differenze di livello potenziale elettrico, tra le masse delle apparecchiature installate nello stesso locale. Questo apparecchio è predisposto con un morsetto posto sotto il basamento per il collegamento di un conduttore equipotenziale. -
Page 6: Assembly And Electrical Connections
ASSEMBLY AND ELECTRICAL CONNECTIONS IMPORTANT Before carrying out any operation, power OFF the coffee machine, close the water mains and wait the pressure drop. The below procedure explains how to fit the Fridge A01 Plus to the coffee machine. Open the front door of the coffee machine and remove the upper nut Remove the pre-cut on the that hold the left side panel. - Page 7 Insert the inlet milk pipe into the pass Place back the master board cover. bulkhead, and then trough the side Place back the left hand side panel hole. panel. Make sure that the serial cable is fixed as in the photo and Connect the power cord on the does not come into contact with Insert the milk inlet pipe into the...
-
Page 8: Starting Up
STARTING UP 1- The fridge can work even if it is not connected to the coffee machine in this case will works with the default temperature parameters. 2 - In case the fridge is connected to the coffee machine ( transmission cable CN 23 ), it is necessary to enable on the machine the “FRIDGE”... -
Page 9: Milk Tank Filling
MILK TANK FILLING After turning on the fridge unit, wait about 30 minutes to reach a temperature of 4 °C, in case the fridge is connected to the coffee machine press the INFO key to show the temperature on the coffee machine display, then remove the tank and fill it with already refrigerated milk. -
Page 10: Cleaning
CLEANING A - CLEANING THE MILK TUBE SYSTEM: We recommend to clean the milk tube system at the end of every working day, carrying on the washing cycle prescribed in the instruction manual of the coffee machine. B - CLEANING THE MILK TANK: Wash the milk tank every day using dish detergent and a non-abrasive sponge, then rinse with plenty of water. -
Page 11: Trouble Shooting
TROUBLE SHOOTING 1) Missing milk alarm Cause: there is no milk into the container inside the fridge. Result: the front led become in pink color. In case the fridge is connected to the coffee machine all milk base drinks are disabled and the the display will show the following message : Missing milk PINK LED... - Page 12 4) 67 Fridge serial alarm . Alarm displayed only in case the fridge is connected to the coffee machine Cause: no data signal from the fridge to the coffee machine, the display will show the following message : , the display will show the following message : Fridge serial Result: all milk base drinks are disabled Solution:...
-
Page 13: Preset Fridge Configuration
PRESET FRIDGE CONFIGURATION PRESET CONFIGURATION DATA : Proceed as follows : power OFF the fridge by means the main switch. move the dip switch N°1 on the board as shown in the following picture : MOVE THE DIP SWITCH N°1 IN POSITION ON With this function, the fridge will be configured with the following default setting : SET-POINT FRIDGE TEMPERATURE : + 4°C / 39,2°F= default value ( variable value : 2 ÷... - Page 14 lb-05073-04-EN Pag. 14 30/09/14...
-
Page 15: Legend
LEGEND Negativo Negative Positivo Positive Ventola per Eletronica Fan for Electronic Ventola per Solubili Soluble Fan Condensatore Capacitor Compressore Compressor Connettore Connector CN …. Deep switch Deep switch Encoder pistone Inferiore Encoder Lower piston Encoder pistone superiore Encoder Upper piston Filtro Antidisturbo Antinoise Filter Fast-on... - Page 16 Sonda Temp. Gruppo Caffè Coffee Group Temp. Probe STCG Sonda Temp. Caldaia Vapore Steam Boiler Temp. Probe STCV Sonda Temp. Lancia Vapore Steam Wand Temp. Probe STLV Triak Boiler Caffè Triak Coffee Boiler TRKC Triak Boiler Vapore Triak Steam Boiler TRKV Potenziometro Display Display Trimmer...
- Page 17 lb-05073-04-EN Pag. 17 30/09/14...
- Page 18 COPERTURA FRONTALE FRIDGE A02 (V2) 14.05125 VITE INOX TE M 4X6 91.00186 LOGO MACCO RESINATO ADESIVO PICCOLO 33.05045 LOGO CARIMALI RESINATO ADESIVO PICCOLO 33.05043 BASE PER LOGO PICCOLO Ø51,5 37.05061.CR DIFFUSORE LED RGB FRIDGE PLUS A01/A02 V2 95.05128 LED SINGOLO RGB FRIDGE A01/02 PLUS (2) 96.05036.L3...
- Page 19 CABL. TRASMISSIONE FRIDGE A01 PLUS (LATO MACCHINA) 03.05047 GUARNIZIONE SPORTELLO CELLA FRIGORIFERA PLASTICA (2) 95.05144 VENTILATORE 230V CELLA FRIGORIFERA V2 96.05210 SPORTELLO CELLA FRIGORIFERA V2 95.05145 PERNO CERNIERA SPORTELLO FRIDGE PLUS V2 A01/A02 16.05081 CONDENSATORE 60uF 96.05264.CA lb-05073-04-EN Pag. 19 30/09/14...
- Page 20 The Carimali product you have purchased is subject to Directive 2002/96/EC of the European Parliament and the Council of the European Union on waste electrical and electronic equipment (WEEE) and, in jurisdictions adopting that Directive, is marked as being put on the market after August 13, 2005, and should not be disposed of as unsorted municipal waste.
Need help?
Do you have a question about the A01-PLUS -V2 and is the answer not in the manual?
Questions and answers