Advertisement
SPEcIFIcATIONS
RATCHET HEAD - Square drive, 36 teeth, sealed flex
DISPLAY - 4-digit LCD, torque units, CCW and battery
condition flags
SEALED KEY PAD
POWER - ON/OFF - auto self check - torque zero -
BATTERY
CONDITION
BATTERY
angle reset
CONDITION
UP - increments torque and angle setting
DOWN - decrements torque and angle setting
UNITS - unit mode select (ft-lb, in-Ib, Nm, °)
FUNCTIONS
SET - torque and angle - adjustable - audible and
AUDIBLE
tactile alert
ALERT
AUDIBLE
TRACK - accumulated angular rotation with real
ALERT
time update
PEAK HOLD - 10 sec. flashing at torque release
ACCURACY (72° F)
ANGLE: +/-1% of reading +/-1° angular velocity >
10°/sec < 180°/sec
TORQUE:
CW
CCW
+/-2%
+/-3% of reading, 20% to 100% of full scale
+/-4%
+/-6% of reading, 10% to 19% of full scale
+/-8% +/-10% of reading, 5% to 9% of full scale
PRESET RANGE
ANGLE: 5 to 360° CW or CCW (Display Resolution 10)
TORQUE: (Display Resolution as shown below)
Model
ft-lb
1002TAA 5.0-100.0
2503TAA 12.5-250.0 16.9-338.9 150-3000 312
OPERATING TEMPERATURE: 55° to 95° F (13° to 35° C)
STORAGE TEMPERATURE: -1° to 122° F (-20° to 50° C)
MEASUREMENT DRIFT
ANGLE: -0.12 Angular Degrees per Degree C
TORQUE: +0.01% of reading per Degree C
HUMIDITY - up to 90% non-condensing
BAR
TORQUE
INCREMENT
GRAPH
UNITS
BAR
TORQUE
INCREMENT
GRAPH
UNITS
TORQUE AND/OR
DECREMENT
ANGLE DISPLAY
KEY
TORQUE AND/OR
DECREMENT
ANGLE DISPLAY
KEY
Nm
in-lb
6.8-135.6
60-1200
DIMENSIONS
PART NUMBER
1002TAA
2503TAA
BATTERY - Two (2) "CR123" Lithium cells, over 80
UNIT
hours continuous operation.
KEY
KEY
UNIT
KEY
KEY
AUTO SHUT-OFF - Auto power OFF will occur after 2
minutes of non-usage to conserve battery power.
1. EQUIPMENT REQUIRED - Precision test bars and
ON/OFF
KEY
certified calibration weights or another torque
ON/OFF
KEY
source, accurate to 0.5% of reading.
2. NOTES
- If the display shows "Err0" at power on, the
wrench is damaged and must be returned to CDI
Torque Products for repair.
- If the display shows "ErrA" in the angle mode,
fastener rotation speed has exceeded the capacity
of the wrench.
- The wrench must be held still during angle mode
reset. Motion is indicated by alternating outside
center segments of the display "- -"
- Remove battery when stored for extended periods.
3. BATTERY REPLACEMENT - Replace with two (2)
"CR123" Lithium cells only (available anywhere).
overload
To replace battery, remove cover on underside of
(ft-lb)
handle (opposite display).
125
SPEcIFIcATIONS
DRIVE
3/8"
1/2"
PLEASE NOTE
100%
30%
5%
LENGTH
WEIGHT
17 in.
2.2 lbs.
27 in.
3.5 lbs.
REPLACE BATTERY
Advertisement
