Instruments - freightliner BUSINESS CLASS M2 Driver Manual

Instruments

MI
12.3 VOLTS
Push
TRIP
12.3 VOLTS
Push
TRIP
12.3 VOLTS
Push
SELECt
MI
Push
MI
n
Push
08/29/2012
NOTE: The engine oil level screen displays for Mercedes-Benz engines only (if equipped and enabled).
Engine Miles/Hours
When the engine miles/hours screen is displayed,
press and hold the mode/reset switch to access the
engines screen submenu.
Setup
The setup menu allows the driver to manage ICU
parameters. The setup screen submenu allows the
driver to enable and change service intervals.
If service intervals are enabled and service distance
or time has been exceeded, the text SERVICE
HOUR/MI (KM) will display at start-up to indicate ve-
hicle service is required.
For each parameter, press and hold the mode/reset
switch to navigate to the parameter change screen.
In each change screen, tap the mode/reset switch to
toggle between options.
The last screen in the setup menu, RESET EE, is for
resetting certain parameters to the original settings.
Press and hold the mode/reset switch to reset the
3.9
123456.7
Default Odometer
Dispay Screen
123456.7
MI Hold
To Reset Trip Miles
123456.7
HOURS Hold
To Reset Trip Hours
To Toggle between Units
Hold
MI<−−−−>KM
dIAG
HOURS Hold
Dispay Diagnostics
n = Number of Active Fault Codes
MI = CYCLE Miles Enabled
HOURS = Cycle Hours Enabled
Fig. 3.5, ICU3 Stationary Screens
CLEAr
Hold
Push
123456.7
To Dispay Total Engine Miles
MI
ENGINE
Push
123456.7
To Dispay Total Engine Hours
HOURS
ENGINE
Push
EnG oIL
Hold
*Lo
Push
SEtUP
**MI **HOURS Hold
**no
**MI = CYCLE Miles Active Mode
**HOURS = CYCLE Hours Active Mode
**no = Service CYCLE Inactive
Push
antilock braking system (ABS), SAMs roll call, auto-
mated transmission display, transmission heartbeat,
sensor fault codes, seat belt switch learning, and en-
gine oil level.
Instruments
Standard instruments are present on every vehicle.
They are listed here in alphabetical order to make
the information easier to find.
Optional instruments, typically located on the auxil-
iary dash panel or right-hand control panel, are not
found on every vehicle. They are listed here in alpha-
betical order, to make the information easier to find.
Air Intake Restriction Gauge
The air intake restriction gauge indicates the vacuum
on the engine side of the air cleaner. On standard
installations, it is mounted on the air intake duct in
the engine compartment. See
for easier viewing, the air intake restriction indicator
Clear Defaults
Dispay Oil Level
*Lo = Oil Level Low
HI = Oil Level High
Blank = Oil Level OK
− − = No Message
Dispay Service Interval
Cycle Screens
f040636b
Fig. 3.6. As an option