JVC LT-32DR9BJ Instructions Manual page 16

5
Set analogue channels
1 Register analogue channels
Auto Program
Country
United Kingdom Ireland
Deutschland Switzerland
France Danmark
Italia Sverige
España Österreich
Norge
Nederland
Suomi
Belgium
If you do not want to register the analogue channels (including cable
TV channels), press the "MENU" button to complete the settings.
To change the country setting, select a country and press the blue
button.
If "ACI Start" appears, start ACI. The cable channels will be
registered quickly. For details, refer to "What is "ACI" (Automatic
Channel Installation)?" (P. 34).
2 Check what was registered
Edit
PR ID CH
_ _ _ _ _ _
AV
01 BBC1 CH 21
02 BBC2 CH 22
03 ITV CH 23
04 CH4 CH 24
05 CH5 CH 25
_ _ _ _ _ _
06
07 CH 26
To edit channels
"Editing analogue channels" (P. 15)
g
6
Finish
To the previous screen
g
Exit
g
To perform initial settings again
Take note that performing initial settings again will cause all channel
related settings and DTV menu settings to be lost. Press the "MENU"
button to display the menu, then press and hold the number button "1" for
more than 3 seconds to start initial settings. If initial setting does not start,
switch to the analogue channel and try again.
Auto Program
(blue)
CH 21
0%
select a channel
If you wish to make changes later, refer to "Service Scan" (P. 14) on the
separate manual "WATCHING DIGITAL CHANNELS" for digital channel
settings, or "Language" (P. 30) and "Auto Program" (P. 30) on this manual
for analogue channel settings.
No digital channels or "Missing or weak signal" message
N
appears
1
Check the following points
Is the TV connected correctly to the aerial?
Change the direction of the indoor aerial.
Is there a digital channels transmission tower nearby?
Turn "Attenuator" to "On" (P. 30), since the radio waves are too
g
strong.
Note
"Attenuator" attenuates the radio waves of analogue broadcast as
well as those of digital broadcast. If some noise or snow appears
when watching an analogue channel, please set "Attenuator" to
"Off" temporarily.
You can check the broadcast signal level of the channel you are
watching. For details, refer to "Signal Check" (P. 15) on the
separate manual "WATCHING DIGITAL CHANNELS".
2
Set digital channels using "Factory Settings". For details, refer to
"Factory Settings" (P. 15) on the separate manual "WATCHING
DIGITAL CHANNELS".
If you still cannot watch digital channels after following the steps above,
there may be a problem with your aerial or its cable. Or, the signal may
be too weak. Consult your retailer
g
Getting started 14