Summary of Contents for Hafler VRM 25
- Page 1 ® V R M V R M V R M V R M S AT E L L I T E S P E A K E R S Y S T E M S...
-
Page 2: Introduction
The VRM5 and VRM6 are optimized for front stereo and rear surround applications. The VRM5 uses a 1” tweeter with a 5” driver and the VRM6 uses a 1” tweeter with a 6” driver. The VRM25 and VRM26 are optimized for front stereo towers and center channel applications. -
Page 3: Table Of Contents
Table of Contents INTRODUCTION TABLE of CONTENTS PERFORMANCE SPECIFICATIONS TECHNICAL DESIGN FEATURES INSTALLATION Typical Studio Installations High Performance Home Theater Installations Location SERVICE POLICY & LIMITED WARRANTY SAFETY PRECAUTIONS – 2 –... -
Page 4: Performance Specifications
"W x 13 "H x 9"D 15 lbs 0.32 cubic feet (9.0) Liters 12.188" 13.375" 7.75" 9.00" VRM25 VRM26 Passive 4th Order Vented 2-way Passive 4th Order Vented D'Appolito Array D'Appolito Array 70Hz-21kHz, +\- 3dB 60Hz-21kHz, +\- 3dB 6 Ohms*... -
Page 5: Technical Design Features
Design Features VRM 5 VRM 25 1” High Frequency Driver Wave Guide 0db/-3db Tweeter Pad Low Frequency Driver Low Frequency Vent Input Terminals (+) and (-) – 4 – VRM 6 VRM 26... -
Page 6: Installation
Installation Typical Home High Performance Theater System Home Theater System This system uses a receiver with that has This system uses a receiver with dedicated built-in amplification amplification preamp/receiver front stage rear surround subwoofer center channel left right center channel left surround right surround subwoofer... -
Page 7: Typical Studio Installations
Your Hafler subwoofer is specially designed for these high levels of excursion and linearity. In order to get the most out of your subwoofer, Hafler has documented the differences between typical Studio and Home Theater installations. -
Page 8: Service Policy & Limited Warranty
Some states do not allow limitations on the length of an implied warranty, so this limitation may not apply. No person is authorized to assume for Hafler any other liability in connection with the sale of •How to obtain service or technical support Please call 1-800-669-9899 for Rockford/Hafler support. -
Page 9: Safety Precautions
TO PREVENT FIRE OR SHOCK HAZARD DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE. 1.Read Instructions All the safety and operating instructions of your Hafler equip ment should be read before power is applied to the equipment. 2.Retain Owner’s Manual These safety and operating instructions should be retained for future reference. - Page 10 1.LEA LAS INSTRUCCIONES Todas las instrucciones de seguidad y operación de su equipo Hafler, deben ser leídas antes de que el equipo sea conectado dléc- tricamente. 2.CONSERVE EL MANUAL DEL PROPIETARIO Estas instrucciones de seguridad y operación, deben ser conservadas...
- Page 11 à éviter toute pénetration dans l’enceinte du matériel. 10.DÉGÂT NÉCESSITANT UNE RÉVISION Le matériel Hafler devrait être révisé par des personnes qualifées de service après-vente, lorsque: A.De objets sont tombés sur le matériel, ou des liquides s’y son dispersés, ou:...
- Page 12 ¨ vermeiden, setzen sie das gerat keinem regen oder extremer feuchtigkeitaus. 1.INSTRUKTIONEN LESEN Alle Sicherheits- und Operationshinweise Ihres Hafler Equipments sollten vor der Inbetriebnahme gelesen werden. 2.BETRIEBSANLEITUNG AUFBEWAHREN Bewahren Sie die Bedienungsanleitung sorgfältig auf, damit Sie in dieser auch in Zukunft nachschlagen können.
- Page 13 Si deve prestar attenzione che oggetti e liquidi, come fluidi deter- genti e bibite, non vengano versati all’interno dell’apparato. 10.RIPARAZIONI Gli apparati Hafler devono essere riparati da personale qualificato quando: A.Oggetti sono caduti all’interno del telaio o quando del liquido è entrato B.Quando l’apparato è...
- Page 14 Notes – 13 –...
- Page 15 Notes – 14 –...
- Page 16 546 SOUTH ROCKFORD DRIVE TEMPE, ARIZONA 85281 U.S.A. 1-888-HAFLER1 / 480-967-3565 WWW.HAFLER.COM MADE IN THE USA This product is designed, developed and assembled in the USA by a dedicated group of American workers. The majority of the components used in the construction of this product are produced by American companies.