EAM30281
TROUBLESHOOTING
The starter motor fails to turn.
TIP
Before troubleshooting, remove the following part(s):
1. Seat
2. Side cover (left/right)
3. Air scoop (left/right)
4. Fuel tank
5. Air filter case cover
1. Check the fuse.
Refer to "CHECKING THE FUSES"
on page 8-49.
OK
2. Check the battery.
Refer to "CHECKING AND
CHARGING THE BATTERY" on
page 8-50.
OK
3. Check the main relay.
Refer to "CHECKING THE RE-
LAYS" on page 8-51.
OK
4. Check the starter motor operation.
Refer to "CHECKING THE START-
ER MOTOR OPERATION" on page
8-55.
NG
5. Check the starter motor.
Refer to "CHECKING THE START-
ER MOTOR" on page 5-46.
OK
6. Check the diodes.
(Diode 1, diode 2, diode 3)
Refer to "CHECKING THE RELAY
UNIT (DIODE)" on page 8-52.
OK
7. Check the starter relay.
Refer to "CHECKING THE RE-
LAYS" on page 8-51.
OK
8. Check the engine stop switch.
Refer to "CHECKING THE
SWITCHES" on page 8-47.
OK
ELECTRIC STARTING SYSTEM
Replace the fuse(s).
NG
• Clean the battery terminals.
• Recharge or replace the battery.
NG
Replace the main relay.
NG
Starter motor is OK. Perform the electric
starting system troubleshooting, starting
OK
with step (6).
Repair or replace the starter motor.
NG
Replace the diodes.
NG
Replace the starter relay.
NG
Replace the engine stop switch.
NG
8-7