Ryobi RY42WB Engine Starting Procedure

WARNING:
This Engine Starting Procedure is not a substitute for reading
the operator's manual. To reduce the risk of injury, user must read and
understand operator's manual before using this product.
50:1 Ratio = Mix 2.6 oz 2-cycle lubricant with
1 gallon of fresh gasoline in separate gas
container. SHAKE. Pour into fuel tank.
Slowly press the primer bulb 10 times.
NOTE: After the 10th press, fuel should be visible in the primer bulb. If it is not,
continue to press the primer until you see fuel in the bulb.
x10
Set the choke lever to CHOKE position.
Pull starter grip and rope sharply until engine attemps to run. Do
not pull starter grip more than 5 times.
Set the choke lever to the RUN position.
Pull the starter grip and rope until the engine runs.
Do not pull starter grip more than 6 times.
NOTE: If engine does not not start, return to the START
position and repeat the steps that follow.
Set the choke lever to the RUN position.
Pull starter grip sharply until engine attemps to run. Do not pull starter grip more than 4 times.
To Stop:
Press and hold the on/stop
switch to the o position ( O ).
ENGINE STARTING PROCEDURE
Go to www.ryobitools.com and register your new tool on-line.
For any questions about operating or maintaining your product, call the Ryobi Help Line!
Your Product has been fully tested prior to shipment to ensure your complete satisfaction.
Troubleshooting tips are also available in your operator's manual.
995000427
3-6-18 (REV:01)