Page 1
Congratulations on the purchase of your new Kustom bass amplifier. Your KB Model draws on decades of amp design and manufacturing experience at Kustom. This model was built from the ground up to offer world-class tone, useful features and reliable performance. Inside this manual, you’ll find valuable information about the amp’s controls and specifications.
FCC Statements 1. Caution: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. 2. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Page 5
KB10 Control Panel 1. Input Jack: ¼-inch input that is intended for bass guitar but will accept other instruments as well. 2. Volume: Adjust this control to set the desired volume level of the amplifier. Note: If you are using an instrument with a built-in active preamp, set its level to mid-position before increasing its volume or distortion may occur.
Page 6
KB10 Back Panel Power Cord: This supplies AC power to the amplifier. If the cord becomes damaged, take the amplifier to an authorized service center for repair. kustom.com...
Page 7
KB10 Suggested Settings The following suggested settings will help you dial in a variety of popular tones. Keep in mind, these are starting points to get you up and running with your KB amplifier. Feel free to experiment to achieve your own signature sounds.
Page 8
Kustom KB10 Specifications ® Output Power 10 Watts 4 Ohms at 10% THD+N Speaker 1 X 10” Custom Designed 4 Ohms Input Impedance Single Input 470K Ohm Gain 48 dB Volume @ Max, All EQ at 12 o’clock S/N Ratio...
Need help?
Do you have a question about the KB10 and is the answer not in the manual?
Questions and answers