K9 2400 K9 2440 2. GENERAL SAFETY INFORMATION 3. INSTALLATION INSTRUCTION 1. Park the vehicle on firm and level ground. This symbol means ATTENTION! Then, engage the parking brake and stop the YOUR SAFETY IS INVOLVED. engine. The message that follows the sym- bol contains important information about safety.
Page 5
K9 2400 K9 2440 < TEMPERED & LAMINATED GLASS SUB- ASSEMBLING > U20SH36A 3. Install the upper frame ass'y (41) and lower U20SH37A frame ass'y (42) to the upper frame stay (it installed in Step 2) and tighten the flange nuts (3).
Page 6
K9 2400 K9 2440 < TEMPERED & LAMINATED GLASS SUB-ASSEMBLING > U20SH40A U20SH42A U20SH41A U20SH42A 3) Fit the cushion bolt (47) to the glass hole 4) Fit the collar (10) and cushion A (19) to the from the outside of the glass. After fitting the screw (4) and insert it to the left / right hole packing 1 (13) from the inside of the glass, on the lower section of the glass.
Page 7
K9 2400 K9 2440 U20SH07A U20SH46A U20SH44A U20SH47A 6. Install the window brush (15) and washer liquid hose (36) to the wiper arm (40). Pass the washer liquid hose through the grommet to pull it out in the driver's seat. Install the wiper arm to the wiper motor shaft and tighten the flange nut (3).
Page 8
K9 2400 K9 2440 U20SH48A U20SH49A 8. Install the wiper motor cover (27) and tighten the screw (28). Install the wire harness cover (33) and tighten the flange bolts (14). U20SH20A U20SH22A U20SH21A 7. Connect the wiper wire harness (29) to the wiper motor. After organizing it with the washer liquid hose as following ROPS frame to secure, pull it out and secure it with a clamp.
Page 9
K9 2400 K9 2440 FOR K92400 FOR K92400 U20SH33B U20SH32A FOR K92440 FOR K92400 & K92440 U20SH54A U20SH24A 10. For K92400 : Connect the main harness 11. For K92400 : Connect the main wire harness connector (A) to the connector connector (A) and washer of wiper motor(29) liquid hose (B) to the motor of...
Page 10
K9 2400 K9 2440 FOR K92400 U20SH50A U20SH51A 12. Install the bracket (39) to the main frame FOR K92440 and tighten the washer bolt (2) and nut (3). Then, install the washer liquid tank bracket (8) on the bracket (38) and tighten the flange bolt (14) to install the washer washer liquid tank (12).
Page 11
K9 2400 K9 2440 U20SH27A U20SH53A 15. Install the lower cover weather strip (35) to the lower cover (34) and tighten the thrust head screws (7) (5 EA) on the lower frame ass'y. Then, fit the caps (11) (4 EA). U20SH52A U20SH29A 14. For K92400 : Connect the vehicle main wire harness connector (A) to the motor switch (30) and install the switch on the panel.