Hot Wheels H8604-0920 Instruction Manual

electricracing.com
INSTRUCTION MANUAL
X
CAUTION: This toy contains functional sharp edges
(tracks and controller plugs) - for use under direct supervision
of an adult. Take extra care during unpacking and use.
START HERE!
Follow the step-by-step instructions to set up your race set.
Please separate the "Assembly Map" page, and keep it handy
during assembly. This page contains the contents list and large-scale
Layout Drawings of the fully-assembled track. You'll probably
need to refer to it as you go.
The Assembly Map looks like this:
(4) 9" STRAIGHT
(1) STRAIGHT (3) 9" RADIUS CURVE (1) 9" RADIUS CURVE
(1) 9" TERMINAL TRACK
(1/4 CIRCLE) (1/4 CIRCLE)
(2) 9" RADIUS CURVE 1/4 CIRCLE
(5) GUARDRAILS
(1) VEHICLE
(DOUBLE-RAIL TRACKS) (1) VEHICLE
(2) CONTROLLERS
Be sure to check out the Troubleshooting Guide on
the back of the Assembly Map.
I. BASIC TRACK ASSEMBLY
Start out on a clean, hard, flat racing surface – not
carpeting. Take out all the track pieces (and other parts)
and check them carefully against the contents list on the
Assembly Map.
This track features a Cliff Hangers
that lets you race up the wall. So make sure you've
chosen an assembly location with a wall surface
handy.
®
H8604-0920
H8604-9993-S1
(12) TRANSITION TRACK (1) SANDPAPER
L L
(4) CRADLES
(1) WALL POWER PACK
B
B
1 = Beginner
2 = Average player
3 = Skilled player
T
T
T
T
A
T
F
T
B T
T
F
T
T
F
T
F
C
B
T
© 2005 Mattel, Inc., PRINTED IN CHINA. All Rights Reserved.
vertical section
®
CAUTI O N - ELECTRI C TOY:
NOT RECOMMENDED FOR CHILDREN UNDER 8 YEARS OF
AGE. AS WITH ALL ELECTRIC PRODUCTS, PRECAUTIONS
SHOULD BE OBSERVED DURING HANDLING AND USE TO
8+
REDUCE THE RISK OF ELECTRIC SHOCK.
MODEL B631S: INPUT: 120VAC, 0.125A, 60Hz.
OUTPUT: 15.0VDC, 0.50A, 7.5VA.
for future reference, as they contain important information.
1.
There are letters molded into each track piece. These
letters are used in these instructions to indicate which
track piece goes where. Following the layout drawings
on the Assembly Map, you may want to lay out your
track – without connecting any track pieces. That way
you'll be able to see how the track layout goes together.
2.
To connect track pieces:
working on the flat surface,
push the ends of the track
pieces together. Make sure
they snap together securely
– you'll hear a click when
they're properly connected. Remember: if the track
connections aren't right, electric power won't flow from
one track section to the next.
3.
To disconnect track pieces,
simply reach underneath where
the track pieces meet and press
the locking tabs together with
thumb and forefinger as shown.
Occasionally the metal track rails will stick up too far
H8604-0921
H8604-9993-S2
from the surface of a track piece, as shown. This may
interfere with vehicle movement. To correct, simply
press the rail back down with your finger. If the
problem persists, please contact Customer Service at
the toll-free number shown in this
manual.
Keep these instructions