Fortin CAN-VSS Installation Manual

CAN-VSS
Copyright © 2006, FORTIN AUTO RADIO INC
VSS SIGNAL GENERATOR USING CAN PROTOCOLS
WIRING / CONNECTION GUIDE WIRING / CONNECTION GUIDE
LED
Front view of the module
START HERE
Make the connections of the CAN-VSS to the
vehicle:
1
Connector 1 (Black):
1.A
Cut off one plug of the Data-Link connector.
Connect the red wire to +12V,
Connect the black wire to GROUND.
1.B
Connector 2 (White):
Make the connections associated with the vehicle in the
VEHICLE FIT GUIDE (P.2)
1.C Connector 3 (White, located at the back of the module):
Make the connections associated with the vehicle in the
VEHICLE FIT GUIDE (P.2)
2
3
TECHNICAL SUPPORT / INFORMATION TECHNICAL SUPPORT / INFORMATION
Neither the manufacturer or distributor of this module is
responsible of damages of any kind indirectly or directly
caused by this module, except for the replacement of this
module in case of manufacturing defects. This module must
be install by qualified technician. This instruction guide may
V
change without notice. isite www.ifar.ca to get latest
version.
ALL RIGHTS RESERVED
N.C.
N.C.
Tach
N.C.
N.C.
2
N.C.
Ignition
conn.
12V Battery (+)
Ground (-)
N.C.
conn.
N.C.
N.C.
(CAN High) Data
(CAN Low) Data
(CAN SW) Data
Connect wire to vehicle
INSTALLATION AND PROGRAMMING INSTRUCTIONS INSTALLATION AND PROGRAMMING INSTRUCTIONS
Press the programming switch while
inserting the main wires harness (
into the CAN-VSS module.
The LED will illuminate to indicate you are in
programming mode, release the
programming button.
Connect the other connectors
( CONN. 2 )
Technical support:
TEL: 514-255-2720
FAX: 514-255-1367
Web: www.ifar.ca
8
Lt. Blue
White
~
Pink
~
Blue
Orange
Purple
Yellow
14
1
Red
Black
1
Blue
White
4
1
Brown/White
Grey
Grey/Black
Brown
4
Connect wire to the cruise control or GPS system
4
5
6
CONN 1 )
For Chrysler/Dodge/Jeep models
*
7
INSTALLATION GUIDE
Made in Canada - V1.0.c - October 26, 2006
W e b s i t e : h t t p : / / w w w . i f a r . c a
See wiring schematic configuration
1
Lt. Blue/Black
White/Black
Pink/Black
Green
Orange/Black
Purple/Black or Purple/White
Yellow/Black
7
3
conn.
Connect the other connectors
( CONN. 3 )
Turn the key to the
Once the LED starts to flash rapidly
turn the key to the
The LED will turn off to indicate the
module has been programmed.
The module is now ready for use.
(* Except chrysler, Dodge, Jeep
models do step 7)
The LED will flash until you
OEM remote lock button
The LED will turn off to indicate the
module has been programmed.
LOCK UNLOCK UNLOCK
The module is now ready for use.
PANIC
N.C.
VSS
N.C.
N.C.
N.C.
N.C.
N.C.
Back view of the module
OUTPUT INPUT
"ON" position .
OFF position .
press the
.
P.1 P.1