Subscribe to Our Youtube Channel
Summary of Contents for EarthQuake PHS3500.1
- Page 1 PowerHouse Shredder PHS3500.1 │PHS5000.1 │PHS8000.1 User Manual Earthquake Sound Corporation 2727 McCone Avenue, Hayward CA, 94545. Tel: 510-732-1000 www.earthquakesound.com ˛ www.earthquakesoundshop.com...
-
Page 2: Table Of Contents
We strongly recommend you to have your new amplifier(s) installed by an authorized Earthquake Sound dealer: Installation professionals employed by your dealer have the correct tools and knowledge to install your amplifier(s) neatly and successfully. -
Page 3: Before You Begin
Regulators are designed to maintain the output voltage of alternators at one level or set-point. Low set-point will not allow for faster charging. High set-point might damage your vehicle’s electrical system. Earthquake recommends that you consult with a qualified auto technician for level setting. C. BATTERIES Batteries are your power storage tanks. -
Page 4: End Of Plate Overview
END OF PLATE OVERVIEW 1. RCA INPUT & OUTPUT: Low level input and output with range of 0.2V to 5V RMS. Be sure to use a high low level adapter if your vehicle does not have a subwoofer output. 2. Crossover: The high pass filter (HPF) is used to filter out unwanted low frequen- cies from 15Hz–80Hz and the low pass filter (LPF) is used to filter out unwanted mid and high frequencies from 80Hz–20kHz. -
Page 5: Specifications
SPECIFICATIONS Specifications are subject to change without notice 5... -
Page 6: Dimensions
DIMENSIONS PHS3500.1 PHS5000.1 PHS8000.1 6 PHS3000.1 / PHS5000.1 / PHS8000.1 Manual... -
Page 7: Crossover & Gain Settings
CROSSOVER & GAIN SETTINGS (ALL MODELS) HPF CROSSOVER SETTINGS LPF CROSSOVER SETTINGS KNOB KNOB SETTING SETTING XOVER XOVER 15Hz 30Hz 40Hz 60Hz 80Hz 80Hz 500Hz 8kHz 15kHz 20kHz SETTING SETTING POINT POINT Specifications are subject to change without notice 7... -
Page 8: Installation
AUXILIARY LIGHTS,ETC.IT DOES NOT ACCOMMODATE FOR BATTERY HIGH CURRENT DEMAND FROM HIGH POWER AMPLIFIER/S. EARTHQUAKE STRONGLY REC- 0 TO 4-GAUGE GROUND CABLE OMMENDS THE USE OF 1 TO 2 AUXILIARY BAT- USE STAR GROUNDING AND KEEP TERIES TO DELIVER SPONTANEOUS POWER TO... -
Page 9: Wiring Preparations
WIRING PREPARATIONS Test the alternator output. Factory alternators will produce 60 to 80 amperes at best. Wear and heat will reduce the output by 40%. Alternator ground (-) must be reinforced, use 4-gauge cable instead of the factory 8-gauge. Alternator positive (+) to battery (+) must be reinforced. Use 4-gauge cables. Check your battery condition. - Page 10 WIRING CONFIGURATIONS CONT. Single Dual 4-Ohm Subwoofer (1-Ohm Minimum ) FUSE Ω Two Dual 4-Ohm Subwoofers 1-Ohm Ω Ω 10 PHS3000.1 / PHS5000.1 / PHS8000.1 Manual...
- Page 11 WIRING CONFIGURATIONS CONT. Two Single 4-Ohm Subwoofers 2-Ohm Ω Ω SENDING SIGNAL TO ADDITIONAL AMPLIFIER/S Rear of typical head unit with subwoofer RCA outputs 5V Max Signal Input Specifications are subject to change without notice 11...
- Page 12 (1) year warranty period is valid only if the product is properly installed by an Earthquake Sound authorized party and the warranty registration card is properly filled out and sent to Earthquake Sound Corporation.If the product is installed by a non-authorized party, a thirty (30) day warranty period applies.
-
Page 13: For Your Records
A copy of the original sales receipt must accompany the product(s) returned for service. Ship the product(s) to: Earthquake Sound Corporation. 2727 McCone Avenue. Hayward, CA 94545 The customer is responsible for the cost of shipping the product(s) to Earthquake Sound Corporation (G) Disputes Resolution: All disputes - between clients and Earthquake Sound Corporation - resulting from the one (1) year limited warranty policy must be resolved according to the laws &... - Page 14 NOTES 14 PHS3000.1 / PHS5000.1 / PHS8000.1 Manual...
- Page 15 Earthquake Sound reserves the right to amend details of the specifications without notice. Copyright © Earthquake Sound Corporation Earthquake Sound Corporation 2727 McCone Avenue, Hayward CA, 94545 • Phone: 510-732-1000 www.earthquakesound.com • www.earthquakesoundshop.com...
Need help?
Do you have a question about the PHS3500.1 and is the answer not in the manual?
Questions and answers