ACG EQ-02 Installation Instructions

Wiring key for the main board.
The ACG pre-amp does not require any soldering all connections are made using screw terminals.
This board is common to all configurations.
Wiring key for the main board.
This board is common to all configurations. Filter stack connection is now duplicated on the reverse
1. Cold (-) input for neck pickup.
of the board.
2. Hot (+) input for neck input.
1. Cold (-) input for neck pickup. Note: Use this Input for the Single Pickup version
3. Cold (-) input for bridge pickup.
2. Hot (+) input for neck pickup. Note: Use this Input for the Single Pickup version
4. Hot (+) input for bridge pickup.
3. Cold (-) input for bridge pickup. (N/A for Single Pickup version)
5. Gain control for neck pickup. (0-+12dB)
4. Hot (+) input for bridge pickup. (N/A for Single Pickup version)
6. Gain control for bridge pickup. (0-+12dB)
5. Gain control for neck pickup.(0-+12dB) ) Note: Use this Gain Control for the Single Pickup version
7. Positive connection for battery clip.
6. Gain control for bridge pickup. (0-+12dB) (N/A for Single Pickup version)
8. Output to jack socket. 7. Positive connection for battery clip. (red wire)
8. Output to jack socket. (Orange wire tip on jack socket)
9. Ground.
9. Ground (green wire ground on jack socket)
ACG EQ-02
ACG EQ-02
Pre-amp installation instructions.
Pre-amp installation instructions.