Bosch Professional GLI 12V-330 Original Instructions Manual page 19

Magnetic attachment (see figure D)
You can use the magnets (6) to attach the cordless worklight to magnetic materials.
Keep your fingers away from the rear side of the stand when attaching the cord-
u
less worklight to surfaces. The strong pulling force of the magnets may trap your fin-
gers.
When attaching the cordless worklight, take care not to leave scratches on delicate sur-
faces.
Fastening to the tripod (see figure E)
You can use the tripod mount (8) to screw the cordless worklight onto a 1/4" tripod (ac-
cessory).
Tighten the cordless worklight using the locking screw of the tripod. Ensure that the tri-
pod has a firm footing.
Maintenance and Service
Maintenance and Cleaning
Remove the batteries from the worklight before carrying out any work on the
u
worklight (e.g. assembly, maintenance, etc.) as well as when transporting and
storing the worklight. There is risk of injury from unintentionally pressing the on/off
switch.
The cordless worklight is maintenance-free and does not contain any parts that need to
be replaced or maintained.
Only clean the cordless worklight's plastic lens with a dry, soft cloth to prevent damage.
Do not use any detergents or solvents.
The light source cannot be replaced. If the light source is defective, the entire cordless
worklight has to be replaced.
After-Sales Service and Application Service
Our after-sales service responds to your questions concerning maintenance and repair of
your product as well as spare parts. You can find explosion drawings and information on
spare parts at: www.bosch-pt.com
The Bosch product use advice team will be happy to help you with any questions about
our products and their accessories.
In all correspondence and spare parts orders, please always include the 10‑digit article
number given on the nameplate of the product.
Bosch Power Tools
English | 19
1 609 92A 7SV | (28.07.2022)