Table of Contents
Advertisement
en Troubleshooting
Fault
Creasing.
Detergent or fabric
softener drips off the
seal and collects on
the door or in the seal
fold.
The spin result is not
satisfactory. The laun-
dry is too wet/too
damp.
Detergent residue on
the damp washing.
42
Cause and troubleshooting
The load is too large.
The next time you run a wash cycle, reduce the
▶
amount of laundry being loaded.
Unsuitable programme for the type of fabric.
Select the programmes that are suitable for the
▶
type of fabric.
Too much detergent/fabric softener in the detergent
drawer.
When dosing liquid detergent and fabric softener,
▶
observe the marking in the detergent drawer and
do not dose above this.
A low spin speed is selected.
The next time you run a wash cycle, set a higher
▶
spin speed.
Start the Schleudern programme.
▶
Drain pipe or water outlet hose is blocked.
Clean the drain pipe and the water outlet hose.
▶
Drain pipe or water drain hose is caught or jammed.
Ensure that the drain pipe and water drain hose are
▶
not kinked or trapped.
The unbalanced load detection system has interrupted
the spin cycle because the laundry is unevenly distrib-
uted.
Redistribute the laundry in the drum.
▶
Note: Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
Start the Schleudern programme.
▶
Unbalance load detection system is using a reduced
spin speed to eliminate an unbalance.
Redistribute the laundry in the drum.
▶
Note: Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
Start the Schleudern programme.
▶
Detergents may contain water-insoluble substances
that deposit on the laundry.
Start the Spülen programme.
▶
Advertisement
Table of Contents
