Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for DFI IDP156P-MS
Summary of Contents for DFI IDP156P-MS
- Page 1 IDP156P-MS User Manual / Installation Guide ver.A_MP_3-1521_13-13...
- Page 2 X WARNING X PRECAUTIONS · Do not use the monitor near water. Warning ! It will cause malfunction if the monitor is operating with unspecified power supply · Do not place the monitor on an unstable cart, stand, or table. If the monitor falls, it can in- adaptor or incorrect power voltage.
-
Page 3: Table Of Contents
Table of Contents Chapter 1 - Introduction ......................4 Features ..........................4 Unpack the monitor ......................4 Check accessory ........................4 Chapter 2 - Installation ......................5 Power Supply & Signal connection ..................5 Function Key Control ......................5 OSD Lock/ Unlock........................ 5 Structure of OSD settings .................... -
Page 4: Chapter 1 - Introduction
Chapter 1 INTRODUCTION Chapter 1 - Introduction X Check accessory - This monitor produces clear images with the vivid color at resolutions from VGA up Please make sure the entire accessory is included: to WXGA and used with graphics adapter of scanning frequency from 30KHz to 82KHz in horizontal sweep while vertical refresh rate is 55Hz to 76 Hz continuously. -
Page 5: Chapter 2 - Installation
Chapter 2 Installation Chapter 2 - Installation X OSD Lock/ Unlock X Power Supply & Signal connection Press “Menu” Key for more than 7 seconds shall lock all control keys’ function. After keys locked, press “Menu” key again for more than 7 second shall unlock the key function. -
Page 6: Chapter 3 - For Your Safety
Chapter 3 For your safety Chapter 3 - For your safety 1. When move the monitor, always switch off power and disconnect all cables to avoid any danger. 2. Please use the power and signal cables correctly when install it. 3. -
Page 7: Chapter 4 - Support Timing Chart
Chapter Support timing chart Chapter 4 - Support timing chart User's Manual | IDP0156P-MS... -
Page 8: Chapter 5 - Projected Capacitive Touch Panel
Chapter 5 Projected Capacitive Touch panel Chapter 5 - Projected Capacitive Touch panel Type 10-Point Project Capacitor Touch Panel Input Mode Finger or Capacitive Touch screen stylus Transparency >85% Touch Control circuitry Build in Touch Panel Module Control Type Touch Control Driver eGalax Touch Driver or Windows build in touch driver X Touch Driver installation: Touch Driver installation:... -
Page 9: Chapter 6 - Mechanical Dimension
Chapter Mechanical dimension Chapter 6 - Mechanical dimension User's Manual | IDP0156P-MS... -
Page 10: Chapter 7 - Fcc Warning Statement
Chapter FCC Warning Statement Chapter 7 - FCC Warning Statement X FCC Class A Warning This equipment has been tested and found to comply with the limits for a Class A digital de- vice, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial en- vironment. -
Page 11: Chapter 8 - Product General Specification
Chapter 8 Product General Specification Chapter 8 - Product General Specification User's Manual | IDP0156P-MS...