Advertisement
Quick Links
Advertisement
Summary of Contents for Yard Craft WOOD ENGLISH GARDEN SWING
- Page 1 WOOD ENGLISH GARDEN SWING ASSEMBLY MANUAL...
-
Page 2: Parts List
Parts List hardware pack 2 chain packs seat back 2 back 2 front arm supports supports 2 Armrests Tools Required For The Job 1/2" wrench 5/32” Hex Key (included) *NOTE: This Hex Key is used to tighten all the fasteners used in the assembly process. - Page 3 Step:1 Step: 2 Place seat, with back supports attached, in this Fasten back supports to seat using 2" bolts. Only position. finger tighten. Be sure the back supports angle away from the seat. Repeat on opposite side. Step:4 Step: 3 From the inside of the seat thread a 1 1/2"...
- Page 4 Step: 5 Step: 6 Fasten eye bolt with a washer and Place seat in this position. Then using 4" hex bolt, lock nut. Repeat steps 4 and 5 on with a washer through the last link on the chain opposite side. pack and through the hole on the armrest, begin fastening the armrest to the back support.
- Page 5 Step: 9 Step: 10 Install the back using lags through the predrilled Place swing in this position and install back as hole on back support and into pilot hole on back directed in next step. cross pieces. Two lags on each end of the swing. Start all four lags then tighten.