GMC Acadia 2022 Owner's Manual page 38

GMC Acadia/Acadia Denali Owner Manual (GMNA-Localizing-MidEast-
15170043) - 2022 - CRC - 5/25/21
38 Seats and Restraints
Personalization Settings later in this section.
The memory recalls may be cancelled at any
time during the recall. See Cancel Memory
Seating Recalls later in this section.
Identifying Driver Number
The vehicle identifies the current driver by
their RKE transmitter number 1 8. The
current RKE transmitter number may be
identified by Driver Information Center (DIC)
welcome message, You are driver x for
memory recalls. This message is displayed
the first few times the vehicle is turned on
when a different RKE transmitter is used. For
Seat Entry Memory to work properly, save
positions to the 1 or 2 memory button
matching the driver number of this welcome
message. To aid in identifying transmitter
IDs, it is recommended to only carry one
RKE transmitter when entering the vehicle.
Perform the following if the welcome
message is not displayed:
1. Move all keys and RKE transmitters away
from the vehicle.
2. Start the vehicle with another RKE
transmitter. A DIC welcome message
should display indicating the driver
number of the other RKE transmitter.
Turn the vehicle off and remove the
other key or RKE transmitter from the
vehicle.
3. Start the vehicle with the initial key or
RKE transmitter. The DIC welcome
message should display the driver
number of the initial RKE transmitter.
Saving Seating Positions
Read these instructions completely before
saving memory positions.
To save preferred driving positions to
1 and 2:
1. Turn the vehicle on or to ACC/
ACCESSORY. A DIC welcome message
may indicate the driver number of the
current RKE transmitter. See Identifying
Driver Number previously in this
section.
2. Adjust all available memory features to
the desired driving position.
3. Press and release SET; a beep will sound.
4. Immediately upon releasing SET, press
and hold memory button 1 or 2 matching
the current Driver s RKE transmitter
number until two beeps sound. If too
much time passes between releasing SET
and pressing 1 or 2, the two beeps will
not sound indicating memory position
were not saved. Repeat Steps 3 and 4 to
try again.
5. Repeat Steps 1 4 for the other RKE
transmitter 1 or 2 using the other 1 or
2 memory button.
It is recommended to save the preferred
driving positions to both 1 and 2 if you are
the only driver.
To save the common exit seating position to
that is used by all drivers for Manually
Recalling Seating Positions and Auto Seat
Exit Memory Recall features, repeat Steps 1
4 using , the exit button.
Manually Recalling Seating Positions
Press and hold 1, 2, or button until the
recall is complete, to recall the positions
previously saved to that button.
Manual Memory recall movement for 1, 2 or
buttons may be initiated and will
complete to the saved memory position if
the vehicle is in or out of P (Park).