Advertisement
Advertisement
Table of Contents
Summary of Contents for Tonka Lift TL7000
- Page 1 Tonka Lift Transmitter & Receiver Instructions 2022 Manual #TL7000 Rev 0 May 2022...
-
Page 2: Product Registration
Figure 2 The QR Code label (Item 1) [Figure 2] is located in the hydraulic control box. Use your mobile device to scan the code. The mobile device will then navigate to the Tonka Lift website. Product Registration Register your hydraulic boat lift online by scanning the QR Code or by going to the website www.tonkalift.com. -
Page 3: Specifications
SPECIFICATIONS Transmitter and Receiver Specifications • RF: 902-928MHz FHSS 6mW • Temperature: Receiver: -40 to 185° F (-40 to +85° C) Transmitter: -4 to 140° F (-20 to 60° C) • Output Rating: 5A each (sourcing) 10A system maximum • Encapsulated electronics inside receiver •... -
Page 4: Operation
OPERATION Transmitter and Receiver Operation To turn the transmitter ON, press and hold any button for at least 2 seconds until both of the green LED flashes, then release. The transmitter is designed with a power saving feature which turns the transmitter OFF after 15 minutes if no buttons are pressed irrespective of receiver status. - Page 5 OPERATION Cloning Transmitter ONLY ONE TRANSMITTER CAN BE ON AT A TIME, THEY CANNOT BE USED SIMULTANEOUSLY - use with CAUTION! Occasionally, it is desirable to have more than one transmitter work with a single receiver. This is accomplished by a process called cloning.
- Page 6 Tonka Lift Inc. 1111 County Road 19 Maple Plain, MN 55359 Phone: (952) 592-8001 Website: www.tonkalift.com © 2021 Tonka Lift...
Need help?
Do you have a question about the Lift TL7000 and is the answer not in the manual?
Questions and answers