Page 3
CTP+LCM)6.95FHD F hsg asm PCBA MB Motor Linea PCBA SUB UP SPK Con Graphite Film Bat FPC con rubber LCM CONN Rubber CAM AF 64M CAM FF 2M CAM AF 13M Coaxial Cable CAM FF 16M MAIN Cop foil F CAM Con Graphite Film PA Tcs Rubber F CAM Rubber MAIN Graphite Film...
Page 4
F CAM Frame MAIN WaterproofFrameasm Card Holder Earphone Rubber USB Rubber DOWN SPK Frame asm screw L2.5 Bat cover asm...
You can charge your device using a charger or by connecting it to the computer using a USB cable (comes with the phone). Use only INFINIX charger and cables. Other chargers or cables may damage the device. This will invalidate your phone warranty.
FCC Statement 1.This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2.Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Page 9
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. SAR Information Statement Your wireless phone is a radio transmitter and receiver. It is designed and manufactured not to exceed the emission limits for exposure to radiofrequency (RF) energy set by the Federal...
Page 10
SAR information on this model phone is on file with the FCC and can be found under the Display Grant section of http://www.fcc.gov/ oet/fccid after searching on FCC ID: 2AIZN-X697 Additional information on Specific Absorption Rates (SAR) can be found on the Cellular Telecommunications Industry Asso-ciation (CTIA) web-site at http://www.wow-com.com.
Page 11
of 10mm must be maintained between the user’s body and the handset, including the antenna. Third-party belt-clips, holsters, and similar accessories used by this device should contain metallic components. Body-worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided.